FWD WHEELCHAIRS

PROCEDURE 13

8. Pull end of retaining strap to secure front battery box

BATTERY TRAY

and front shroud in place.

 

9.Position the rear battery box onto the battery tray as shown in FIGURE 8.

10.Connect the battery cable from the rear battery box to the rear battery connectors on the wheelchair frame.

11.Bundle excess joystick cable and tie wrap together. See DETAIL "A".

12.Position excess joystick cable between retaining strap and rear battery box. See DETAIL "A".

13.Clip the rear retaining strap together.

14.Pull end of retaining strap to secure battery box and joystick in place.

15.Install the rear shroud. Refer to REMOVING/INSTALL- ING SHROUDS in PROCEDURE 9 of this manual.

DETAIL"A"

 

Joystick

Rear Battery

Cable

Box

Tie-Wrap

 

Retaining

 

 

 

 

 

Strap

Rear Shroud

Retaining

Pull this end of

 

retaining strap to

 

Strap

 

 

 

secure battery

 

 

 

box in place

Slot

Rear

Battery

Box

Battery

 

 

Retaining

Battery

Front

Strap

Connections

on Side of

Tray

Battery

Front

Wheelchair

 

Box

Frame

 

 

Shroud

 

 

 

FIGURE 8 - INSTALLING/REMOVING BATTERY BOXES

R2JR

WARNING

Pinch point exists between battery tray and bat- tery bracket.

Folding Battery Tray for Transport (FIGURE 9)

1.If necessary, remove the front and rear shroud. Refer to REMOVING/INSTALLING SHROUDS - FWD WHEELCHAIRS in PROCEDURE 9 of this manual.

2.Remove the battery boxes from the wheelchair. Refer toINSTALLING/REMOVINGBATTERYBOXESinthis procedure of the manual.

3.Perform one (1) of the following:

A.FOR R2BASIC and R2STANDARD - Lift up on the pin side of the battery tray and rotate UP towards the battery tray pivot.

B.FOR R2JR - Lift up on the notched side of the bat- tery tray and rotate UP towards the battery tray pivot.

4.Fold the wheelchair. Refer to TRANSPORTING RANGER II FWD in this procedure of the manual.

Unfolding Battery Tray for Use (FIGURE 10)

1.Unfold the wheelchair. Refer to TRANSPORTING RANGER II FWD in this procedure of the manual.

2.Perform one (1) of the following:

A.FOR R2BASIC and R2STANDARD-

WARNING

Make sure pins of battery tray are secure in the mounting slots of the hanger bracket, otherwise injury or damage may result.

Rotate the pin side of the battery tray DOWN against the mounting slots on the hanger bracket.

B.FOR R2JR - Rotate the notched side of the battery tray and DOWN against the battery tray stop.

3.Install the battery boxes. Refer to INSTALLING/RE- MOVING BATTERY BOXES in this procedure of the manual.

4.If necessary install the front shroud. Refer to REMOV-

ING/INSTALLING SHROUDS - FWD WHEEL- CHAIRS in PROCEDURE 9 of this manual.

F

W

D

W

H

E

E

L

C H A I R S

51

Page 51
Image 51
Invacare Ranger II250 SERIES Folding Battery Tray for Transport Figure, Unfolding Battery Tray for Use Figure