Invacare Ranger IIBASIC F W D W H E E L C H A I R S, Fwd Wheelchairs, FOR MODEL R2JR FIGURE

PROCEDURE 13 FWD WHEELCHAIRS

F

W

D

W

H

E

E

L

C H A I R S

FOR MODEL R2JR (FIGURE 15).

NOTE: Right and left is determined by sitting in wheel- chair.

1.Remove the footrests. Refer to INSTALLING /RE- MOVING FOOTRESTS in PROCEDURE 3 of the Owner's Manual, part number 1080722.

2.Remove the battery boxes from the wheelchair. Refer toINSTALLING/REMOVINGBATTERYBOXESinthis procedure of the manual.

3.Remove the battery tray. Refer to REMOVING BAT- TERY TRAY in this procedure of the manual.

4.Remove the two (2) mounting screws that secures the existing right battery tray hanger bracket to wheelchair frame.

5.Secure NEW battery tray hanger bracket to wheel- chair frame with the existing two (2) mounting screws. Securely tighten.

6.Reinstall battery tray, battery boxes, and footrests by reversing STEPS 1-3.

Mounting Screws

Battery Tray

Hanger Bracket

Wheelchair

Frame

FIGURE 15 - REPLACING RIGHT BATTERY TRAY

HANGER BRACKET FOR MODEL R2JR

Replacing Left Battery Tray Hanger Bracket

FOR MODELS R2BASIC AND R2STANDARD (FIGURE 16).

NOTE: Right and left is determined by sitting in wheel- chair.

1.Remove the battery boxes from the wheelchair. Re- fer to INSTALLING/REMOVING BATTERY BOXES in this procedure of the manual.

2.Loosen, but do not remove the rear locknut that se- cures MKIV controller to the wheelchair.

3.Perform one (1) of the following:

A.WHEELCHAIR EQUIPPED WITH FLIP-UP RE- MOVABLE FOOTBOARD - Remove the hex screw and spacer that secures the existing left battery tray hanger bracket and footboard mount- ing bracket to the wheelchair frame.

B.WHEELCHAIR NOT EQUIPPED WITH FLIP-UP REMOVABLE FOOTBOARD - Remove the front hex screw that secures the existing left battery tray bracket to the wheelchair frame.

4.Remove the locknut that secures existing left battery tray hanger bracket and MKIV controller from the wheelchair.

5.Remove the existing left battery tray hanger bracket from the wheelchair.

6.Line up the mounting holes in the new battery tray hanger bracket with the front mounting hole and rear stud on the wheelchair frame.

7.Perform one (1) of the following:

A.WHEELCHAIR EQUIPPED WITH FLIP-UP RE- MOVABLE FOOTBOARD - Reinstall the hex screw and spacer that secures the new left bat- tery tray hanger bracket and footboard mounting bracket to the wheelchair frame. Use Loctite 242 and torque to 156-in/lbs.

B.WHEELCHAIR NOT EQUIPPED WITH FLIP- UP REMOVABLE FOOTBOARD - Reinstall the front hex screw that secures the new left battery tray hanger bracket to the wheelchair frame. Use Loctite 242 and torque to 156-in/lbs.

8.Reinstall locknut. Use Loctite 242 and torque to 156- in/lbs.

9.Torque the rear locknut that secures MKIV controller to the wheelchair to 156-in/lbs.

Wheelchair	Battery Tray Hanger Bracket
Frame

MKIV

Controller

Spacer
	Hex Screw
Locknut	Footboard
Rear Locknut - Loosen,	Mounting
	Bracket
but Do Not Remove

FIGURE 16 - REPLACING LEFT BATTERY TRAY HANGER BRACKET FOR MODELS R2BASIC AND

R2STANDARD

54