Invacare Ranger II250 SERIES Changing Width of Battery Tray Figure, Battery Tray Pins Hex Bolts

MWD WHEELCHAIRS PROCEDURE 14

Changing Width of Battery Tray (FIGURE 9)

NOTE: This procedure is only necessary when changing the width of the wheelchair.

1.Remove the battery tray from the wheelchair. Refer to INSTALLING/REMOVING BATTERY TRAY in this procedure of the manual.

2.Remove the hex bolt and locknut that secure one (1) of the battery tray pins to the battery tray.

3.Refer to FIGURE 9 to determine the mounting hole in the battery tray that corresponds to the width of the wheelchair.

4.Reposition the battery tray pin to the mounting hole determined in STEP 3.

5.Secure the battery tray pin to the battery tray with the hex bolt and locknut.

6.Repeat STEPS 2-5 for the other three (3) battery tray pins.

7.Reinstall the battery tray onto the wheelchair. Refer to INSTALLING/REMOVING BATTERY TRAY in this procedure of the manual.

Battery Tray Pins

Battery Tray

Hex Bolts

	16-inch Wheelchair
Locknuts	18-inch Wheelchair
	20-inch Wheelchair

FIGURE 9 - BATTERY TRAY - CHANGING WIDTH OF

BATTERY TRAY

REPLACING WIRING HARNESS (FIGURE 10)

1.If necessary, remove the front and rear shrouds. Re- fer to REMOVING/INSTALLING SHROUDS in PRO- CEDURE 10 of this manual.

2.Remove the battery boxes. Refer to INSTALLING/ REMOVING BATTERY BOXES in this procedure of manual.

3.Disconnect the wiring harness (BLUE) from the con- troller connector (BLUE).

4.Remove the two (2) phillips screws and spacers that secure the rear battery connector to the wheelchair frame.

5.Remove the two (2) phillips bolts and locknuts that secure the front battery connector to wheelchair frame.

6.Remove the two (2) phillips bolts and locknuts that secure the wiring harness to the charger cable mount- ing bracket.

7.HIGH BACK CAPTAIN'S SEAT MODEL WHEEL- CHAIRS ONLY (DETAIL "A") - Perform the following:

A.Disconnect the limit switch. Refer to DISCON- NECTING/CONNECTING LIMIT SWITCH in this procedure of the manual.

B.Remove the phono jack nut that secures the phono jack to the limit switch bracket.

8.Note the position of the tie wraps that secure the ex- isting wiring harness and motor cables to the cross- braces.

9.Cut the tie wraps that secure the existing wiring har- ness and motor cables to the crossbraces.

10.Remove the existing wiring harness from wheelchair.

11.Position the rear battery connector of the new wiring harness on the wheelchair frame as shown in FIG- URE 10 and secure with the two (2) phillips screws and spacers.

12.Position the front battery connector on the wheelchair frame as shown in FIGURE 10 and secure with the two (2) phillips bolts and locknuts.

13.Secure the wiring harness to existing charger cable mounting bracket on the seat frame with the two (2) phillips bolts and locknuts.

14.HIGH BACK CAPTAIN'S SEAT MODEL WHEEL- CHAIRS ONLY - Perform the following:

A.Position the new phono jack on the limit switch bracket.

B.Reinstall the phono jack nut onto the new phono jack and tighten securely.

C.Connect the limit switch. Refer to DISCONNECT- ING/CONNECTING LIMIT SWITCH in this pro- cedure of the manual.

M W D

W

H

E

E

L

C H A I R S

71