Invacare Ranger IIJR, Ranger IISTANDARD Replacing Stabilizer Wheel, Type C Stabilizer Assemblies

PROCEDURE 14 MWD WHEELCHAIRS

M W D

W

H

E

E

L

C H A I R S

Replacing Stabilizer Cylinders for Type C Stabilizer Assemblies (FIGURE 17)

NOTE: Refer to STABILIZER INDENTIFICATION in the beginning of this section to determine correct stabilizer assembly.

1.Place a 1/2-inch block underneath drive wheel.

2.Remove the top mounting screw and locknut that se- cures the top of the stabilizer cylinder to the wheel- chair frame.

2.Note the mounting position of the existing stabilizer cylinder for proper installation of the new stabilizer cyl- inder.

3.Remove the bottom mounting screw, washers and locknut that secures the bottom of the stabilizer cylin- der to the swing arm.

4.Remove the existing stabilizer cylinder.

	Top	Top of
zRight Hand side of	Mounting
Wheelchair Frame	Screw	Stabilizer
		Cylinder

Bottom of

Stabilizer

Cyliner

Locknut

Washer

There is no

need to remove this mounting screw and locknut

Bottom

Locknuts Mounting

Screw

Swing

Arm

NOTE: Stabilizer assembly exploded away for clarity. It is not necessary to remove the stabilizer assembly from the wheelchair frame.

FIGURE 17 - REPLACING STABILIZER CYLINDERS FOR

TYPE C STABILIZER ASSEMBLIES

5.Secure the bottom of the NEW stabilizer cylinder to the mounting hole on the swing arm noted in STEP 2 with the mounting screw, washers, and locknut. Loosely tighten.

6.Secure the top of the stabilizer cylinder to the wheel- chair frame with the top mounting screw and locknut. Loosely tighten.

7.Torque both mounting screws to 13 ft/lbs and then back off 1/8 to 1/4 turn.

NOTE: The length of the new stabilizer cylinder must be adjusted to match the length of the stabilizer cylinder just removed.

8.Measure the distance between the top mounting hole and the bottom mounting hole on the existing stabilizer cylinder. Note this distance as distance “A” . Refer to DETAIL “A”

9.Place the wheelchair on a flat surface so that the stabi- lizer wheels can hang freely.

10.Loosen the jam nut, located underneath the hex nut adjuster, by turning CLOCKWISE as viewed from the top.

11.Rotate the hex nut adjuster in one (1) of the following directions:

A.Rotating the hex nut adjuster CLOCKWISE, as viewed from the top, will move the stabilizer wheel up.

B.RotatingthehexnutadjusterCOUNTER-CLOCK- WISE, as viewed from the top, will move the stabi- lizer wheel down.

12.When distance “A” is achieved, noted from STEP 8, retighten the jam nut by rotating COUNTER-CLOCK- WISE to lock the hex nut adjuster in position.

13.Place the wheelchair on a flat surface with all six wheels in contact with the surface.

REPLACING STABILIZER WHEEL

Replacing Stabilizer Wheel for Type A and Type B Stabilizer Assemblies (FIGURE 18)

NOTE: Refer to STABILIZER INDENTIFICATION in the beginning of this section to determine correct stabilizer as- sembly.

NOTE: Note the position of the stabilizer wheel for installa- tion of the new stabilizer wheel.

1.Remove the hex bolt and locknut that secure the exist- ing stabilizer wheel and spacers to the stabilizer plates.

76