Invacare Ranger IIBASIC Repositioning Motors, M W D W H E E L C H A I R S, Mwd Wheelchairs

PROCEDURE 14 MWD WHEELCHAIRS

M W D

W

H

E

E

L

C H A I R S

15.Repeat STEPS 2-14 for the opposite side of the wheel- chair, if necessary.

16.Tighten the jamnut on the stabilizer cylinder.

WARNING

Stabilizers MUST be adjusted BEFORE use, oth- erwise they will NOT operate properly.

17.Adjust the front stabilizer(s). Refer to ADJUSTING STABILIZERS in this procedure of the manual.

18.If necessary, install the front shroud. Refer to REMOV- ING/INSTALLING SHROUDS in PROCEDURE 10 of this manual.

Locknuts (STEPS 3,

13)

Wheelchair

Frame

TOP Hex Bolt (STEPS 3, 13)

BOTTOM Hex	Stabilizer
Bolt (STEPS	Cylinder
4, 14)	Stabilizer Plates
Stabilizer Cylinder Pivot (STEPS 6, 11)
	Jam Nut (STEPS 2, 11, 16)
	Adjustment Nut (STEPS 7, 9)
	Plate (STEPS 7, 10)

Stabilizer Cylinder Spring

(STEPS 8, 9)

Inspect for Wear

Stabilizer Cylinder

FIGURE 16 - REPLACING STABILIZER CYLINDER

SPRINGS

REPOSITIONING MOTORS

WARNING

Repositioning the motors MUST be performed by an authorized Invacare dealer or qualified technician.

2.Remove the battery boxes. Refer to INSTALLING/ REMOVING BATTERY BOXES in this procedure of the manual.

3.Remove the tip from the existing clutch handle.

4.Remove the pin that secures the existing clutch handle to the motor/gearbox.

5.Disconnect the existing clutch handle from the motor/ gearbox.

6.Feed the existing clutch handle through the wheel- chair frame.

7.Remove the rubber tip from the new clutch handle.

8.Install the new clutch handle onto the wheelchair.

NOTE: Make sure the new clutch handle is pointing to- wards the outside of the wheelchair.

9.Install the rubber tip onto the new clutch handle.

10.Connect the clutch handle to the motor/gearbox and line up the mounting holes in the clutch handle and motor/gearbox.

11.Insert the pin through the clutch handle and motor/ gearbox as shown in DETAIL "A" in FIGURE 21.

NOTE: Make sure the detent ball on the pin is fully visible.

12.Repeat STEPS 3-11 for the opposite side of the wheel- chair, if necessary.

13.Reinstall the battery boxes. Refer to INSTALLING/ REMOVING BATTERY BOXES in this procedure of the manual.

14.If necessary, install the shrouds. Refer to REMOV- ING/INSTALLING SHROUDS in PROCEDURE 10 of this manual.

Tip (STEPS 3, 7, 9)

Clutch Handle

(STEPS 5, 8)Outside of

Wheelchair

Motor/

Gearbox

REPLACING CLUTCH HANDLES -

R2BASIC AND R2250 SERIES (FIGURE 21)

1.If necessary, remove the shrouds. Refer to REMOV- ING/INSTALLING SHROUDS in PROCEDURE 10 of this manual.

DETAIL "A"	Pin (STEPS 4, 11)	Motor/Gearbox
Clutch Handle (STEP 10)		Detent Ball

FIGURE 21 - REPLACING CLUTCH HANDLES -

RANGER II MWD BASIC

78