PROCEDURE 5 | SEAT/BACK |
S E A T
/
B A C K
8.Slide the loose top half of the back cane through the new back upholstery.
9.Using the mounted back cane as a guide, reinstall the two (2) hex bolts that secure the top half of the back cane to the bottom half of the back cane.
NOTE: Make sure the back canes are mounted to the same height.
WARNING
The top and bottom half of the back canes MUST be tightened securely together BE- FORE using the wheelchair, otherwise in- jury or damage may occur. Use Loctite 242 on the hex bolts and torque to
10.Use Loctite 242 on the hex bolts and torque into the back canes to
11.While holding the hex bolt, reinstall the locknut and torque to
12.Repeat STEP 11 for the other hex bolt and locknut.
13.Securely tighten the new back upholstery to the back canes with the two (2) phillips screws and washers.
14.Secure the bottom of the new back upholstery to the wheelchair frame with
REPLACING CAPTAIN'S SEAT (FIGURE 3)
1.Remove the Captain's seat from the wheelchair. Refer toREMOVING/INSTALLINGCAPTAIN'SSEATinPRO- CEDURE 5 of the owner's manual part number 1080722.
2.Remove the four (4) hex screws and washers that secure the existing captain's seat to the seat frame assembly.
3.Line up mounting holes in the new captain's seat with mounting holes in the seat frame assembly.
4.Apply Loctite 242 to the hex screws.
5.Install the four (4) hex screws and washers through the seat frame assembly and into the new captain's seat. Tighten securely.
6.Install the new captain's seat onto the wheelchair. Re- fer to REMOVING/INSTALLING CAPTAIN'S SEATin PROCEDURE 5 of the owner's manual, part number 1080722.
Captain's Seat
NOTE: Clean upholstery with warm DAMP cloth and mild
Seat Frame
Seat Frame
detergent to remove superficial soil.
WARNING
Laundering or moisture will reduce flame retardation of the upholstery.
Assembly
Assembly
Washers
Hex Screws (Apply
Loctite 242)
FIGURE 3 - REPLACING CAPTAIN'S SEAT
20
