![SURFACE COOKING, CONT.](/images/new-backgrounds/60475/6047511x1.webp)
SURFACE COOKING, CONT.
COOKTOP
To prevent the cooktop from discol- oring or staining:
•Clean cooktop after each use.
•Wipe acidic or sugary spills as soon as the cooktop has cooled as these spills may discolor the porcelain.
Unlike a range with stan- dard gas burners, this
cooktop does not lift-
up nor is it removable.
Do not attempt to lift the cooktop for any
SIMMER BURNER
This burner is located in the left front position. The simmer burner offers a lower BTU flame for delicate sauces or melting chocolate.
* BTU ratings will vary when using LP gas.
BURNER GRATES
The grates must be properly positioned before cooking. Improper installation of the grates may result in chipping of the cooktop.
Do not operate the burners without a pan on the grate. The grate’s porce- lain finish may chip without a pan to absorb the heat from the burner flame.
Although the burner grates are durable, they will gradually lose their shine and/or discolor, due to the high temperatures of the gas flame.
SEALED BURNERS
The sealed burners of your range are se- cured to the cooktop and are not designed to be removed. Since the burners are sealed into the cooktop, boilovers or spills will not seep underneath the cooktop.
However, the burner heads should be cleaned after each use. The head portion of the burner is easily removed for cleaning. (See page 15 for cleaning directions.)
HIGH PERFORMANCE
BURNER (12,000 BTU*)
There is one high speed burner on your range, located in the right front position. This burner offers higher speed cooking that can be used to quickly bring water to a boil and for
NOTES:
•A properly adjusted burner with clean ports will light within a few seconds. If using natural gas, the flame will be blue with a deeper blue inner cone.
If the burner flame is yellow or is noisy, the air/gas mixture may be incorrect. Contact a service technician to adjust. (Adjustments are not covered by the warranty.)
With LP gas, some yellow tips on the flames are acceptable. This is normal and adjustment is not necessary.
•With some types of gas, you may hear a “popping” sound when the surface burner is turned off. This is a normal operating sound of the burner.
•If the control knob is turned very quickly from hi to lo, the flame may go out, particularly if the burner is cold. If this occurs, turn the knob to the OFF position, wait several seconds and relight the burner.
•The flame should be adjusted so it does not extend beyond the edge of the pan.
5