Operating the Teleconference System
In the Teleconference mode, both videos of teleconference can be displayed on a single
2 | - |
monitor by PinP. |
|
Connected party | User |
| ENCODE | DECODE | HOLD | IN 1 | IN 2 | POWER |
CF | PLAY | STOP | HOLD | SELECT | PinP |
|
Network
| ENCODE | DECODE | HOLD | IN 1 | IN 2 | POWER |
CF | PLAY | STOP | HOLD | SELECT | PinP |
|
Number display | 4.7. | 6. 1. |
<Connected party> Teleconference mode
1. Set the power to ON.
(Off)
The number display circles, IP address is displayed as shown on page 48, and then turns off when ready.
Number display 2. | 3.7. | 6. 1. |
<User> Teleconference mode
1. Set the power to ON.
(Off)
The number display circles, IP address is displayed as shown on page 48, and then turns off when ready.
2. Enter the number of the party to connect (number registered in Edit No. of
TELEPHONE BOOK screen).
• Use and to select the digit to
input.
• Use and to increment/decre- ment the number of the selected digit (0~9).
Memo
• Pressing or first will display the number of
the previous connection.
3. Press the PLAY button.
The entered number will flash.
4. The sent number will flash. Press the PLAY button.
(Connection will not be established unless
this button is pressed.)
The sent number will flash.
For automatic connection without pressing the PLAY button, set Acceptance in the NETWORK SETUP screen to Auto.
“HHH” will be displayed if the party is not registered in TELEPHONE BOOK.
42