| ALARM |
| SERIAL 1 |
| SERIAL 2 |
|
| RS485 | RS232C | SERVICE CONTROL |
|
| AUDIO | VIDEO | VIDEO | VIDEO |
|
IN | OUT | OUT | IN 1 | IN 2 |
|
AC IN |
|
|
|
|
|
L |
|
| LOOP | LOOP |
|
|
|
| |||
|
|
| THRU | THRU | |
R |
|
|
|
|
|
| RESERVED |
| OPEN | OPEN | |
Introduction
@2 | @1 @0 !9 | !8 | !7 | !6 | !5!4!3!2 |
0 Connection number displayG [75Ω /ΟΠΕΝ] Ινπυτ 1, 75Ω τερ∝ιναλ σωιτχη
While in the Teleconference or Monitor mode, the connecting destination number is displayed. The display will flash when establishing connection and the lamp will change to a constant display when connection is established.
While in the ISMA mode, the number of streams transmitted is displayed.
ACF card slot
CF card can be inserted after removing the screw.
( See “Inserting a CF Card”, page 17)
BRXD display lamp
The lamp turns on when data is being sent/received via the C
75Ω terminal switch for the H VIDEO IN 1 terminal. Select “OPEN” during
(Factory setting: 75Ω )
H [VIDEO IN 1] Video input t
Input terminal 1 for video signal. Used for inputting video
signal from a camera, etc.
I [VIDEO OUT] Video output t
Output terminal for video signal.
Used only when in the Teleconference or Monitor mode.
J [AUDIO OUT] Audio output t
Output terminal for audio signal. Used for connecting
C
DLINK display lamp
The lamp turns on when the
ready for communication.
E[75Ω /ΟΠΕΝ] Ινπυτ 2, 75Ω τερ∝ιναλ σωιτχη
75Ω terminal switch for the F VIDEO IN 2 terminal. Select “OPEN” during
(Factory setting: 75Ω )
Used only when in the Teleconference or Monitor mode.
(RESERVED: Currently cannot be used)
K [AUDIO IN L/R] Audio input
Input terminal for audio signals.
L and R channels can be used when in the ISMA mode. The L channel terminal can be used when in the tele- conference or Monitor mode.
L [AC IN] AC power input ter
Input commercial AC120V using the included power cord.
( See “Connecting the Power Cord”, page 19)
F [VIDEO IN 2] Video input terminal 2
Input terminal 2 for video signal. Used for inputting video
signal from a camera, etc.
9