When in the Monitor mode, pressing the button on the monitoring side will light the button and display 2 videos in- putted to the camera side as shown on the right.
When pressing the 3SELECT button during PinP display, the displayed videos will switch.
When in the Teleconference mode, videos of both sides are displayed as shown on the right.

Names and Operations of Parts

Front

!1

 

ENCODE

DECODE

HOLD

 

IN 1

IN 2

 

POWER

 

 

 

 

 

 

 

 

 

CF

PLAY

STOP

HOLD

SELECT

PinP

 

q

!0

o

i u y t r e w

1 [POWER] Power button and5 display[STOP] Stoplamp button

Turns the unit power on and off.

Press securely until a click is heard.

The display lamp turns green when the power is on.

Pressing the button will terminate connection and the

0connection number display will turn off. ( See “Operations”, pages 42 and 43)

2 [PinP] Picture-in-Picture6 [PLAY]buttonPlay button

(VIDEO1)

(VIDEO2)

Monitor mode

(Other party)

(User)

Teleconference mode

Pressing the button will establish connection. The connecting destination will be displayed in the 0 connection number display.

( See “Operations”, page 42)

7 [CF] Compact Flash button

The button will light when a CF (Compact Flash) card is inserted in the A CF card slot. During the Monitor mode, recording can be made on the camera side. Pressing this button while the lamp is on will start image recording and the lamp will flash. While recording is in progress, pressing the button again will stop re- cording.

( See “About the Alarm”, page 56)

3[SELECT IN 1, IN 2] Select8 [ENCODE, DECODE] Encode and button and display lamps lamps

Selects the input signal between VIDEO IN 1 and VIDEO IN 2. When in the Monitor mode, pressing the button on the monitoring side select input videos to camera side. Pressing the button on the camera side select input videos to camera side.

When in the Teleconference mode, pressing the button select input videos to own side.

Displays the operation status of the unit.

When the ENCODE lamp is on, the unit is operating as an encoder.

When the DECODE lamp is on, the unit is operating as a decoder. When both lamps are on, the unit is operating as a codec.

9 Number Select buttons

4

Used when selecting a connecting destination. The cur-

[HOLD] Operation lock button and display lamp

Pressing the button for 3 seconds or more will light the display lamp and button operations other than the 1 [POWER] button will be locked. Pressing the button again for 3 seconds or more while the lamp is on will cancel the lock and the lamp will turn off.

(Factory setting: HOLD)

rently selected digit will be indicated using a flashing display.

•Press ￿ or ￿ to select the digit.

•Press ￿ or ￿ to increase or decrease the value of the selected digit.

8