Command Table (none of the commands require arguments)
Command name | Operation | |
|
|
|
stat | Network information, encoder information and connection information are displayed. | |
set mode | Available modes to select are displayed. | |
|
|
|
set mode Camera | Camera mode is set. | |
set mode Monitor | Monitor mode is set. | |
|
|
|
set mode Teleconference | Teleconference mode is set. | |
|
|
|
set mode ISMA_Server | ISMA Server mode is set. | |
|
|
|
set mode User_Mode_xxx | User more is set. * xxx is the mode name saved by the user. | |
| Example: set mode User_Mode_Camera | |
| (This command is invalid when user mode is not saved.) | |
set aec | Displays on/off of the echo canceller. | |
| Default setting differs depending on the mode. | |
| Teleconference mode: on | |
| Monitor mode: off | |
| Camera mode: off | |
| ISMA Server mode: off (AEC is unavailable) | |
| * Set to off when audio is not used. Disabling echo canceller improves video quality. | |
| * Set to on when the echo canceller is necessary for audio communication. | |
|
|
|
set aec on | Enables the echo canceller. | |
|
|
|
set aec off | Disables the echo canceller. |
|
set tcp | Displays whether the transporting of audio and video stream is UDP or TCP. | |
| Default setting is UDP. When setting to TCP, smoother audio and video playback in a | |
| network with low reliability may be achieved. | |
| * In the case of TCP mode, used ports are audio: 49298 and video: 49398. Port settings | |
| in NETWORK SETUP screen are not used. In the UDP mode, used ports are audio: | |
| 49200 and video: 49300. | |
| * In the case of RTCP, transmission will be done in UDP even when in TCP mode. When | |
| TCP is selected, used ports for RTCP are audio: 49299 and video: 49399. | |
| * Multicast is UDP protocol. Multicast does not turn to TCP. | |
|
|
|
set tcp on | Switches to TCP mode. | |
|
|
|
set tcp off | Switches to UDP mode. |
|
.set brmon start | Displays the output bitrate. | |
| (Not available in the ISMA Server and Monitor modes) | |
|
|
|
.set brmon stop | Disables the output bitrate display. | |
| (Not available in the ISMA Server and Monitor modes) |
|
set mode default | Initialize settings of current mode to the factory settings. * Invalid for user mode. | |
|
|
|
reboot | Restarts the unit | |
|
|
|
ctrl+c or exit | Quit the access by terminal software | |
|
|
|
071:GET IPDISPLAY | Shows current setting of IP address display at start | |
|
| |
071:SET IPDISPLAY ON | Enables IP address display at start |
|
|
|
|
071:SET IPDISPLAY OFF | Disables IP address display at start | |
|
|
|
370: GET DHCPCLIENT | Show status of DHCP | |
|
|
|
371: SET DHCPCLIENT ON | Sets to DHCP mode (enabling of this command requires the | |
| or the power to be turned off and turned back on.) | |
|
|
|
371:SET DHCPCLIENT OFF | Set to Manual mode (enabling of this command requires the | |
| or the power to be turned off and turned back on.) | |
|
|
|
For details concerning other commands, contact the nearest
54