JVC GR-DVL9600 LCD Monitor/Viewfinder Indications, Stop Recording, Press IND. ON/OFF Button

Recording Start/Stop Button

IND. ON/OFF Button

Tape remaining time indicator

25 min min

(Now calculating)

90min

89min

3min

2min

(Blinking)

1min

(Blinking)

0min

(Blinking)

EN15

4 STOP RECORDING

Press the Recording Start/Stop Button again to stop recording.

•The camcorder re-enters the Record-Standby mode.

NOTES:

●The image will not appear simultaneously in the LCD monitor and the viewfinder. No image appears on the LCD monitor when the viewfinder is pulled out. It is not

possible to shoot using both LCD monitor and view- finder. However, during Interface Shooting (☞ pg. 17) the image appears simultaneously in the LCD monitor and the viewfinder.

●The cassette holder cannot be opened unless a power supply is attached.

●There may be a delay after you open the cassette cover until the holder opens. Do not use force.

●The tape remaining time is only displayed in the viewfinder as shown.

●The indicated tape remaining time is approximate.

●The time required to calculate and to display the remaining tape length, and the accuracy of the calcula- tion, may vary according to the type of tape used.

●“TAPE END” appears when the tape reaches its end, and the power goes off automatically if left in this condition for 5 minutes. “TAPE END” also appears when a cassette whose tape is already at its end is loaded.

●If the Record-Standby mode continues for 5 minutes, the camcorder’s power shuts off automatically. To turn the camcorder on again, push back and pull out the viewfinder again or close and re-open the LCD monitor.

●When a blank portion is left between recorded scenes on the tape, the time code is interrupted and errors may occur when editing the tape. Continue recording from

where you stop so that there are no gaps by following “Recording from the middle of a tape” (☞ pg. 19).

●During recording, sound is not heard from the speaker. If you want to hear the sound, connect optional head- phones to the headphones connector. The sound volume at this point is the same as the level it was adjusted during playback.

●To turn the tally lamp off during recording, refer to pgs. 28 and 30.

LCD Monitor/Viewfinder Indications

You can make the LCD monitor/Viewfinder indications appear/disappear.

1 PRESS IND. ON/OFF BUTTON

To turn off the indications, press IND. ON/OFF for more than 1 second.

Press again for more than 1 second to make the indications reappear.

NOTE:

It is impossible to make the tape running indicator “444” and warnings etc. disappear from the LCD monitor or the viewfinder. For the indications that can be removed,

☞pg. 74 and 75.