JVC GR-DVL9600 specifications Digital Dubbing, Make Connections, Start Playback

To DV IN/OUT

DV cable (optional)

Lock Button

PLA

Y

O

F

F

5S

Power Switch

EN53

Digital Dubbing

It is also possible to copy recorded scenes from the camcorder onto other video unit equipped with a DV connector. Since a digital signal is sent, there is little if any image or sound deterioration.

1 CONFIRM POWER-OFF STATUS Make sure the camcorder’s power is off.

2 MAKE CONNECTIONS

Connect the camcorder to your video unit equipped with a DV connector using the DV cable as shown in the illustration.

3 START PLAYBACK

Press PLAY (4) to play back the source tape.

4 START RECORDING

To DV IN/OUT

Video unit equipped with DV connector

	RM-V711U
T W	(provided)
	PLAY (4)
	STOP (5)

While watching the playback on the monitor, engage the DV connector-equipped video unit’s record mode from the spot on the source tape you want to begin recording.

NOTES:

●It is recommended to use the AC Power Adapter/Charger as the power supply instead of the battery pack (☞ pg. 7).

●If the remote control is used when both the player and recorder are JVC video units, both units will perform the same operation. To prevent this from happening, press the buttons on both units.

●For Digital Dubbing, this camcorder can be connected only to one device at a time. This camcorder can also be used as a recorder.

●If a blank portion is played back on the player during dubbing when this camcorder is used as a recorder, this camcorder enters Record-Standby mode so that an usual image is not dubbed.

●Even though the DV cable is connected correctly, some- times the image may not appear in step 3. If the above occurs, turn off power and make connections again.

●If “Playback Zoom” (☞ pg. 56), “Playback Special Effects” (☞ pg. 57) or “Snapshot” is attempted during playback, only the original playback image recorded on the tape is output from the DV OUT connector.

●During Digital Dubbing, the scenes recorded in High Speed Recording mode are divided into 2, and the image is

displayed both in the upper and lower halves of the screen (☞ pg. 45).

●Be sure to use a DV cable with the noise filter.

●Be sure to wind the DV cable twice around the core filter attached to the end connected to the camcorder.

To Use This Camcorder As A Recorder . . .

1.Turn the Power Switch to “ ” while pressing down the Lock Button located on it.

2.Connect the DV cable as shown in the illustration and load a cassette to record on.

3.Press the Recording Start/Stop Button to engage the Record-Pause mode. “DV IN” appears on the screen.

4.Press the Recording Start/Stop Button to start recording. “DV IN” changes to “ DV IN ”.

5.Press the Recording Start/Stop Button again to engage the Record-Pause mode. “ DV IN ” returns to “DV IN”.

NOTES:

●During Digital Dubbing, the image is dubbed using the recording mode selected in the Recording Menu (☞ pg. 10).

●Digital Dubbing is performed in the sound mode recorded on the original tape, regardless of the current “SOUND MODE” setting (☞ pg. 30).