JVC GR-DVL9600 Flash Brightness Adjustment, Access Flash Adjustment, Press the Select Dial

Power lamp

		F
	F
Y	O		5S
A
L
P

Lock Button

EN27

Flash Brightness Adjustment

When a snapshot (☞ pg. 24) is taken in the dark the camcorder flashes (☞ pg. 26) while adjusting the brightness automatically. You can also adjust the flash brightness manually. When you find that the snapshots you took look too bright or too dark, adjust it manually.

1 SELECT OPERATION MODE

Set the Power Switch to “ ” or “ ” while pressing down the Lock Button, and pull out the viewfinder fully or open the LCD monitor fully.

2 ACCESS MANUAL MODE ITEM MENU Press the Select Dial and move the highlight bar to “FLASH ADJ.” by rotating the Select Dial.

3 ACCESS FLASH ADJUSTMENT

Press the Select Dial.

Select Dial

Display

FOCUS	AUTO
EXPOSURE	AUTO
W. BALANCE	AUTO
FADER	OFF
/ WIPE
P. AE	OFF
/ EFFECT	0
FLASH ADJ.

4END

FOCUSAUTO

EXPOSURE AUTO

W. BALANCE AUTO

	FADER	OFF
	/ WIPE
	P. AE	OFF
	/ EFFECT	0
4	FLASH ADJ.
	END
FLASH
0

Power Switch

Manual Mode Item Menu

Flash Adjustment

The Manual Mode Item Menu disappears, “FLASH” appears in the upper left corner and a number appears next to the indication to allow adjustment of the flash manually on the screen.

4 ADJUST BRIGHTNESS OF FLASH Rotating the Select Dial upward increases the number of the brightness adjustment indicator and rotating the Select Dial downward decreases it.

•The adjustment range is from –3 to +3.

5 ACTIVATE BRIGHTNESS OF FLASH Press the Select Dial. The flash brightness adjustment is complete. The indication “FLASH” changes to “MANUAL”.

NOTES:

●When the battery power is low or when “FLASH” is set to “OFF” in the Recording Menu, the screen to set “FLASH ADJ.” does not appear.

●When you change the subject you are shooting or the shooting location, set it back to ±0 as described in step 4 and take a snapshot to check the flash brightness. After doing this adjust to your desired brightness.