JVC GR-DVL9600 specifications EN Using the Remote Control Unit, Select Scenes, SET EDIT-IN Point

60ENUSINGTHEREMOTECONTROLUNIT(cont.)

Power Switch

PLA

Y

O

F

F

5S

Program

	I N	OUT MODE
1	– – – – : – – ~
2

3~

4~

5~

6~

7~

8~

TIME CODE	– – : – –	4
TOTAL	0 0 : 0 0

Random Assemble

Editing Menu

Remote sensor

SELECT SCENES (cont.)

6 SET EDIT-IN POINT

At the beginning of the scene, press EDIT IN/OUT on the remote control. The Edit-In position appears on the Random Assemble Editing Menu.

7 SET EDIT-OUT POINT

At the end of the scene, press EDIT IN/OUT. The Edit-Out position appears on the Random Assemble Editing Menu.

8 USE FADE/WIPE ON SCENE TRANSITION (IF NECESSARY)

Press FADE/WIPE.

•Cycle through the effects by pressing repeatedly, and stop when the one you want is displayed.

•If you select a Fade/Wipe effect for an Edit-Out point, the effect is automatically applied to the following Edit-In point.

•You cannot use a Picture Wipe/Dissolve at the end of the last scene.

•When you use Fade/Wipe effects, that time is included in the total time (this does not apply to Picture Wipe/Dissolve).

9 USE PLAYBACK SPECIAL EFFECTS (IF NECESSARY, ☞ pg. 57)

RM-V711U
(provided)	T W
	PLAY
FADE/WIPE	EFFECT
EDIT IN/OUT	R.A.EDIT
	ON/OFF
	CANCEL

Press EFFECT.

10 REGISTER ADDITIONAL SCENES Repeat steps 6 through 9.

•To change previously registered points, press CANCEL on the remote control. The registered points disappear, one at a time, from the most recently registered point.

•If you are not using Fade/Wipe or Program AE with special effects, repeat steps 6 and 7 only.

NOTES:

●When the source tape has more than 2 identical time codes (☞ pg. 19), the camcorder may not find the Edit-In point you chose and a malfunction may occur.

●When choosing a scene, set Edit-In and Edit-Out points so that there is a relatively large difference between them.

●If the search time for an in-point exceeds 5 minutes, the recording deck’s Record-Standby mode will be cancelled and editing will not take place.

●If there are blank portions before or after the Edit-In and Edit-Out points, a blue-backed screen may be included in the edited version.

●Since time codes register time only as accurately as seconds, the time code total time may not match the total programm time exactly.

●Turning off the camcorder’s power erases all registered Edit-In and Edit-Out points.

●If you select Sepia or Monotone mode from Program AE with special effects, you cannot use the Dissolve or Black & White Fader. In this case the Dissolve or Black & White indicator begins blinking. Once the next Edit-In point is registered, the effect is turned off. To combine these effects, use Sepia or Monotone during recording, then use Dissolve or Black & White Fader during Random Assemble Editing.

●It is not possible to use Fade/Wipe effects and Program AE with special effects during Random Assemble Editing using a DV cable.