JVC KD-LH401 service manual Removing the connector board See Figs.3 to

3.2.2Removing the connector board (See Figs.3 to 5)

CAUTION:

Before disconnecting the flexible wire from the pickup, solder the short-circuit point on the pickup. No observance of this in- struction may cause damage of the pickup.

(1)Remove the screw B fixing the connector board.

(2)Solder the short-circuit point on the pickup.

(3)Disconnect the flexible wire from the pickup.

(4)Move the connector board in the direction of the arrow to release the two joints b.

(5)Unsolder the wires on the connector board if necessary.

CAUTION:

Unsolder the short-circuit point after reassembling.

Wires

B

Connector board

Joints b Short-circuit point Pickup

Fig.3

Short-circuit point

(Soldering)

Flexible wire

Pickup

Fig.4

B

Connector board

Flexible wire

Frame

Fig.5

1-14 (No.MA063)