JVC KD-LH401 Searching for a station manually Manual search, English, Select the band FM1 - 3, AM

Searching for a station manually: Manual search

1 Select the band (FM1 – 3, AM).

Each time you press the

button, the band changes as

follows:

Note:

This receiver has three FM bands (FM1, FM2, FM3). You can use any one of them to listen to an FM broadcast.

2 Press and hold ¢ or 4 until “Manual Search” starts flashing on the display.

3 Tune in to a station you want while “Manual Search” is flashing.

To tune in to stations of higher frequencies

To tune in to stations of lower frequencies

•If you release your finger from the button, the manual mode automatically turns off after about 5 seconds.

•If you hold down the button, the frequency keeps changing (in 50 kHz intervals for FM and 9 kHz for AM—MW/LW) until you release the button.

If the sound quality decreases and the stereo effect is lost while listening to an FM station

In some areas, adjacent stations may interfere with each other. If this interference occurs, this unit can automatically reduce this interference noise (the initial setting when shipped from the factory). However, in this case, the sound quality will be degraded and the stereo effect will also be lost.

If you do not want to degrade the sound quality and to lose the stereo effect, rather than to eliminate the interference noise, see “To change the FM tuner selectivity—IF Filter” on page 49.

ENGLISH

11