JVC KD-LH401 service manual Removing the select arm R / link plate See Figs.27 and, Reference

3.2.13Removing the select arm R / link plate (See Figs.27 and 28)

•Prior to performing the following procedure, remove the top plate assembly.

(1)Bring up the select arm R to release from the link plate (joint a') and turn as shown in the figure to release the two joints b' and joint c'.

(2)Move the link plate in the direction of the arrow to release the joint d'. Remove the link plate spring at the same time.

REFERENCE:

Before removing the link plate, remove the mode sw..

3.2.14Reattaching the Select arm R / link plate (See Figs.29 and 30)

REFERENCE:

Reverse the above removing procedure.

(1)Reattach the link plate spring.

(2)Reattach the link plate to the link plate spring while joining them at joint d'.

(3)Reattach the joint a' of the select arm R to the first peak of the link plate while joining the two joints b' with the slots. Then turn the select arm R as shown in the figure. The top plate is joined to the joint c'.

CAUTION:

When reattaching the select arm R, check if the points e' and f' are correctly fitted and if each part operates prop- erly.

	Joint c'	Link plate Joint r
Select arm R	Joint b'

Joint b'

Joint a'

Fig.27

Link plate spring

Top plate Joint d'

Link plate

Fig.28

Link plate spring

Select arm R Joint c'

Joint d'

Joint b'

Joint b' Joint a'

Fig.29

Joint a'

Point e'

Link plate

Point f'

Fig.30

(No.MA063)1-23