JVC KD-LH401 service manual Removing the loading roller assembly See Figs.31 to

3.2.15 Removing the loading roller assembly (See Figs.31 to 33)

•Prior to performing the following procedure, remove the clamper assembly and top plate assembly.

(1)Push inward the loading roller assembly on the gear side and detach it upward from the slot of the joint g' of the lock arm rivet assembly.

(2)Detach the loading roller assembly from the slot of the joint h' of the lock arm rivet assembly.

The roller guide comes off the gear section of the loading roller assembly.

Remove the roller guide and the HL washer from the shaft of the loading roller assembly.

(3)Remove the screw J attaching the lock arm rivet assembly.

(4)Push the shaft at the joint i' of the lock arm rivet assembly inward to release the lock arm rivet assembly from the slot of the L side plate.

(5)Extend the lock arm rivet assembly outward and release the joint j' from the boss of the chassis rivet assembly. The roller guide springs on both sides come off at the same time.

CAUTION:

When reassembling, reattach the left and right roller guide springs to the lock arm rivet assembly before reat- taching the lock arm rivet assembly to the chassis rivet assembly. Make sure to fit the part k' of the roller guide spring inside of the roller guide. (Refer to Fig.34.)

Roller guide

HL washer

Loading roller assembly

Roller guide spring

Part k' Loading roller assembly

Roller guide spring

Fig.32

Chassis rivet assembly

Boss

Loading roller assembly

J

L side plate

Roller guide

Joint h'

Roller guide spring

Roller guide spring

Joint g'

Loading roller assembly

Roller guide spring

Lock arm rivet assembly

Fig.31

Roller guide spring

Lock arm rivet assembly

Joint i'

Joint j'

Fig.33

Roller guide

HL washer

Roller shaft assembly

Loading roller

Lock arm rivet assembly Roller guide spring

Fig.34

1-24 (No.MA063)