JVC KD-LH401 Removing the pickup unit See Figs.14 to, Reattaching the pickup unit See Figs.14 to

3.2.7Removing the pickup unit (See Figs.14 to 18)

•Prior to performing the following procedure, remove the top cover, connector board and chassis unit.

(1)Remove the screw D and pull out the pu. shaft holder from the pu. shaft.

(2)Remove the screw E attaching the feed sw. holder.

(3)Move the part e of the pickup unit upward with the pu. shaft and the feed sw. holder, then release the joint f of the feed sw. holder in the direction of the arrow. The joint g of the pickup unit and the feed rack is released, and the feed sw. holder comes off.

(4)Remove the pu. shaft from the pickup unit.

(5)Remove the screw F attaching the feed rack to the pickup unit.

3.2.8 Reattaching the pickup unit (See Figs.14 to 17)

(1)Reattach the feed rack to the pickup unit using the screw F.

(2)Reattach the feed sw. holder to the feed rack while setting the joint g to the slot of the feed rack and setting the joint f of the feed rack to the switch of the feed sw. holder correct- ly.

(3)As the feed sw. holder is temporarily attached to the pickup unit, set to the gear of the joint g and to the bending part of the chassis (joint h) at a time.

CAUTION:

Make sure that the part i on the underside of the feed rack is certainly inserted to the slot j of the change lock lever.

(4)Reattach the feed sw. holder using the screw E.

(5)Reattach the pu. shaft to the pickup unit. Reattach the pu. shaft holder to the pu. shaft using the screw D.

Feed sw. holder

Joint f

E

Pu. shaft

Joint g

D

Pu. shaft holder	Pickup unit Part e
Fig.14

Pickup unit

Part e

	Feed rack	Feed sw. holder
		Fig.15
		Pu. shaft
	Part i Pickup unit
	E		D
		Joint f
	Slot j	Joint h	Pu. shaft holder
Joint g

Feed sw. holder

Fig.16

F Feed rack

Pickup unit

Fig.17

Pickup unit

Joint g

Feed rack

Joint f

Feed sw. holder

Fig.18

(No.MA063)1-19