17

Setting the satellite controller

Satellite receiver

The following procedure is required if you receive satellite programmes through a satellite receiver. Approximately 20 seconds before a timer recording starts, the unit sets its input mode to “L-2” (or “SAT”) and automatically changes the programme position numbers on the satellite receiver by sending a signal to your satellite receiver.

Remote sensor

Transmitter

Satellite controller

(Supplied)

Suggested location of the satellite controller

Installing satellite controller

1Situate the satellite controller.

Place the satellite controller so that the path between its transmitter and the remote sensor on the satellite receiver is unobstructed.

2Attach the satellite controller.

Fix securely using the adhesive strip attached on the back of the satellite controller.

Satellite receiver

3Make connections.

Be sure to connect the L-2 IN connector on the rear to the 21-pin SCART connector on the satellite receiver.

NOTE

When connecting your satellite receiver, refer to its instruction manual.

4Connect the satellite controller to the unit.

21-pin SCART cable

(not supplied)Connect the satellite controller to the SAT CONTROL connector on the rear.

 

 

DVD/HDD

DVD

 

L-1

DVD DIGITAL OUT

VIDEO

AUDIO

VIDEO SIGNAL

 

OUT

OUT

SELECTOR

 

PCM / STREAM

VIDEO

LEFT

 

 

 

 

 

 

 

 

COAXIAL

OPTICAL

 

 

COMP.

Y/ C

L-2

 

 

 

 

/ RGB

 

 

 

 

S-VIDEO

RIGHT

 

 

 

IN/OUT

IN

SAT CONTROL

IN

OUT

AV ANTENNA

COMPU LINK

XV-DDV1SL

Page 17
Image 17
JVC XV-DDV1SL manual Installing satellite controller, Situate the satellite controller, Attach the satellite controller