JVC LET0239-001A, XV-DDV1SL Setting the built-in TV tuner, Press or 5to move to Auto CH SET, then

[ENTER]

[CANCEL] [SET UP]

26 BBC1

33 BBC2

23 ITV

30 CH4

37 CH5

[ENTER] [SET UP]

(Example) If CH4 is received on channel position 4.

[ENTER] [SET UP]

70 CHANGING THE INITIAL SETTINGS (cont.)

6Press the number button “0” to select “TV PROG” or “SAT.”

•In this example, select “TV PROG.”

•Select “SAT” to enter a programme position number of the satellite receiver.

7Press ° or 5 to enter the programme position

number for the station of the selected Guide Program number, then press ENTER.

This is the number you select on this unit or on the satellite receiver to tune into the station.

•To timer-record a satellite

programme with the VIDEO PLUS+® system, install the supplied satellite controller and perform the procedure described on page 17.

8Repeat steps 5 to 7 to store more Guide Program numbers.

9Press SET UP twice to finish the setting.

Setting the built-in TV tuner

It is required to memorize all necessary stations in the programme positions in order to record TV programmes. Set the built-in TV tuner manually only in the following cases.

•When Auto Channel Set has not been performed correctly by Auto Setup or TV-Linked Setup.

•When you have moved to a different area or if a new station starts broadcasting in your area.

To set the built-in TV tuner automatically—Auto Channel Setup

Auto Channel Setup automatically assigns the programme position numbers to all receivable stations (their Guide Program numbers are also set automatically) during Auto Channel Setup in your area. These stations stored in the programme positions can be selected by using the HDD/TV PR +/– buttons (without going through any vacant programme positions).

1Press SET UP.

2Press 3 or 2 to move to “INITIAL SET UP,” then press °.

3Press 3or 2to move to “TUNER SET,” then press

ENTER.

4Press °or 5to move to

“AUTO CH SET,” then	TUNER SET
press ENTER.	AUTO CH SET
	MANUAL CH SET

5Press °or 5to move to either “AUTO SET” or “T-V

LINK,” then press ENTER or 3.

Auto Channel Setup starts.

• If you have connected the unit to a TV offering

T-V Link via a 21-pin	[SET UP]
SCART cable, select “T-V Beginning		End

LINK.”

• As Auto Channel Setup progresses, the “ ” mark on the AUTO SET screen moves from left to right. When Auto Channel Setup is finished, the confirmation screen appears after the message

“SCAN COMPLETED.”

•The stations the unit has located appear on the confirmation screen— programme positions (PR), station channels (CH) and station names (ID—see pages 73 and 74).

The confirmation screen and the programme currently being broadcasted by the flashing station appear alternately for about 8 seconds each. To view the other stations preset in the programme positions, press 3 / 2 / ° / 5.

6Press SET UP three times to finish the setting.

NOTES

•Using the confirmation screen, you can skip or add stations, enter station names and perform other operations. Refer to pages 71 to 73 for the procedures.

•This unit memorizes all detected stations even if reception of some of them is poor. You can delete those stations with an unacceptable picture (see page 71).

•Depending on reception conditions, stations may not be stored in order, and the station names and/or the Guide Program numbers may not be stored correctly.

If the Guide Program numbers are not set properly when you timer-record a TV programme using the VIDEO PLUS+® system, the unit will not record a TV programme you want (see page 40).

•Fine tuning is performed automatically during Auto Channel Set. If you want to perform tuning manually, see page 72.

•If “SCAN COMPLETED –NO SIGNAL–” appears on the TV, make sure of the aerial connection, then press ENTER; Auto Channel Set will take place again.