JVC LET0239-001A Activate Automatic Satellite Recording, Before performing the following steps

46 TIMER RECORDING (cont.)

Automatic Satellite Recording

This function allows you to automatically record a satellite programme using the timer equipped for the satellite receiver connected to the L-2 IN connector on the rear.

When the signals come into the unit from the satellite receiver, the unit automatically turns on and starts recording.

•When the satellite receiver is turned off by its timer, this unit also turns off automatically (into standby mode).

3

ATTENTIONS

•Be sure not to turn on the satellite receiver before Automatic Satellite Recording start recording; otherwise, this unit will start recording when you turn on the satellite receiver manually.

•If you have connected any external component other than a satellite receiver to the L-2 IN connector, activating Automatic Satellite Recording will start recording automatically when the external component is turned on.

•While Automatic Satellite Recording is activated, recording timer is temporarily deactivated. When Automatic Satellite Recording is over, recording timer is activated again.

Before performing the following steps:

•Set the timer on the satellite receiver correctly.

•When using the remote control, slide the DVD/TV/ HDD selector to the right (HDD), then press ENTER.

1Set the timer equipped for the satellite

receiver correctly.

•For timer setting of the satellite receiver, refer to the instruction manual supplied for the satellite receiver.

2Select the recording speed.

Press REMAIN/REC MODE on the remote control repeatedly until the recording speed you want is selected (see page 24).

3Activate Automatic Satellite Recording.

Press and hold SAT (timer) for about 2 seconds so that the button itself illuminates (in orange).

• The unit automatically enters standby mode.

To deactivate Automatic Satellite Recording, press SAT

(timer).

To cancel Automatic Satellite Recording while recording is being made, press (STANDBY/ON).

NOTES

•The lamp next to the ¦ (record) button lights and the SAT (timer) button starts flashing while Automatic Satellite Recording is in progress.

•Some satellite receivers emit signals even if the power is off. Automatic Satellite Recording is not possible with these satellite receivers. (In this case, The lamp to the ¦ (record) button lights and the SAT (timer) button starts flashing when you activate Automatic Satellite Recording.)

•When using Automatic Satellite Recording, you cannot set a different recording speed for each programme. To do it, use Automatic Satellite Recording separately for each programme.

•With some satellite receivers connected, this unit may not be able to be synchronized to start and stop recording as exactly as set by the timer equipped with these satellite receivers.

•If you activate Automatic Satellite Recording while the satellite receiver is turned on, this unit does not start Automatic Satellite Recording.

•You can also record a programme from your cable system in the same way if the system has a timer.

•Just Clock (see page 69) does not work while Automatic Satellite Recording is being activated.