EN 17

E Select the TV system.

Press rt to place the pointer next to the appropriate TV system (refer to the table below).

Major Countries/Areas

TV System

 

 

Australia, New Zealand, Kuwait, U.A.E.,

 

Indonesia, Singapore, Thailand,

B/G

Malaysia, Iran, Saudi Arabia, Egypt,

 

Morocco, Lebanon, Iraq

 

 

 

China, Mongolia, Russia

D/K

 

 

Hong Kong

I

 

 

F Start Auto Channel Set

Press OK or e.

DO NOT press any button on the unit or remote control while Auto Set Up is in progress.

Receivable channels in your area are automatically assigned to the PR +/– buttons, and non-receivable channels are skipped.

As Auto Set Up progresses, the “q” mark on the TV screen moves

from left to right.

 

AUTO CH SET

When Auto Set Up is completed,

 

PLEASE WAIT

the lowest position number will

 

 

appear on the front display

START

FINISH

panel. If “SCAN COMPLETED –

■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ – – – – – – –

 

 

NO SIGNAL–” is displayed on the TV screen, make sure that the

aerial cable is connected to the unit properly and press OK on the remote control. The unit will try Auto Set Up again.

NOTES:

If there is a power cut, or if you press 1 or SET UP MENU while Auto Set Up is in progress, Auto Set Up will be interrupted; be sure to turn off the unit power once and try again from step A.

If no sound accompanies the picture or the audio sounds unnatural on some channels that have been stored by Auto Set Up, the TV system setting for those channels may be incorrect.

Select the appropriate TV system for those channels.

( pg. 86, “TV System Selection — When you see the picture but the audio can’t be heard or sounds unnatural”)

ATTENTION

If you perform Auto Set Up successfully during installation, there's no need to separately perform the Clock Set or Channel Set procedures, but if adjustments become necessary, they can be performed as follows:

Tuner setting  pg. 83

Clock setting  pg. 87

After “Auto Set Up” is completed, perform “Monitor Set (DVD deck)” on page 18.

Page 17
Image 17
JVC HR-XVS20AA, LPT0762-001B manual Select the TV system, Start Auto Channel Set, Press OK or e