JVC HR-XVS20AA, LPT0762-001B manual Access the G-CODEProgram screen, Engage the unit’s timer mode

EN 33

D Access the G-CODEProgram screen.

NOTES:

● To Change The Stop Time:

— press STOP +/– after pressing OK in step D. You can

Press OK, then the G-CODEProgram screen appears (if you’re just starting out, “P1” appears).

– P1 –

NO. 12345678

START STOP

21:00 22:00

SP

DATE TV PROG

25.041

: [OK]

compensate for anticipated programme schedule delays.

● To Timer-Record Weekly Or Daily Serials:

— after pressing OK in step D, press WEEKLY (number key

“9”) for weekly serials or DAILY (number key “8”) for daily

serials (Monday — Friday). Either “WEEKLY” or “DAILY”

appears on the TV screen. Pressing the button again makes the

corresponding indication disappear.

● You can programme this unit to timer-record as many as 8

programmes. If you try to programme the unit to record a

IMPORTANT

Make sure the channel position number you wish to record is displayed; if not, see “G-CODE™/SHOWVIEW™ System Setup” on page 31 and set the Guide Program number correctly.

●If the number you entered is invalid, “ERROR” appears on the TV screen. Press & and input a valid G-CODEnumber.

●If the “G-CODE/SHOWVIEW SETUP” screen appears, see “ATTENTION” on page 33.

E Set the tape speed.

Press SP/LP/EP (p).

●Select the appropriate colour system with “PAL/MESECAM” and “NTSC”. ( pg. 77, 78)

F Return to the normal screen.

Press PROG or OK. “PROGRAM COMPLETED” appears on the TV screen for about 5 seconds, then the normal screen appears. If “PROGRAM OVERLAPPED” appears

ninth, “PROGRAM FULL” appears on the TV screen. To record

the extra programme, you must first cancel any unnecessary

programmes. ( pg. 37)

Satellite Receiver Users

To timer-record a satellite broadcast using the G-CODE/ SHOWVIEW system:

APerform steps A – G.

BSet the satellite receiver to the appropriate channel before the selected programme begins.

CLeave the satellite receiver’s power on.

ATTENTION

Guide Program Number Set

“G-CODE/SHOWVIEW SETUP” appears after performing step D if the Guide Program number for the G-CODEnumber you entered has not been set.

Press rt or the number keys to input the channel position number on which your unit receives that station, then press OK or e to set the Guide Program number. The G-CODEProgram screen appears.

on the TV screen, see page 38.

●Repeat steps B – F for each additional programme.

G Engage the unit’s timer mode.

Press # (TIMER). The unit turns off automatically and “#” appears on the front display panel.

●To disengage the timer mode, press # (TIMER) again.

G-CODE/SHOWVIEW SETUP

GUIDE PROG TV PROG

2– –

[0–9] OR [ /] : SELECT

[PROG] : EXIT

(Example)

To timer-record a RTR programme with the G-CODEsystem.

*If your unit receives RTR on the channel position 2, press OK or e after entering “2”.