JVC HR-XVS20AA, LPT0762-001B manual Timer recording won’t work, Re-perform the clock and/or timer

			EN 93
TIMER RECORDING (S-VHS deck)
	SYMPTOM	POSSIBLE CAUSE	CORRECTIVE ACTION
1.	Timer recording won’t work.	● The clock and/or the timer have been set	Re-perform the clock and/or timer
		incorrectly.	settings.
		● The timer is not engaged.	Press # (TIMER) and confirm that “#” is
			displayed on the front display panel.
2.	Timer programming is not possible.	● Timer recording is in progress.	Timer programming can’t be performed
			while a timer recording is in progress.
			Wait until it finishes.
3.	“#” on the front display panel won’t	● The timer is engaged but there’s no	Load a cassette with the record safety tab
	stop blinking.	cassette loaded.	intact.
4.	“#”, “” and “$” on the front	● The loaded cassette has had its record	Remove the cassette and cover the hole
	display panel won’t stop blinking.	safety tab removed.	with adhesive tape, or insert a cassette
			with the record safety tab intact.
		● The end of the tape was reached during	The programme may not have been
		timer recording.	recorded in its entirety. Next time make
			sure you have enough time on the tape to
			record the entire programme.
5.	“#” blinks for 10 seconds and the	● # (TIMER) has been pressed when there	Check the programmed data and re-
	Timer mode is disengaged.	are no programs in memory, or the timer	program as necessary, then press #
		record information has been	(TIMER) again.
		programmed incorrectly.
6.	The G-CODE/SHOWVIEWsystem does	● The unit’s channel positions have been	Refer to “G-CODE™/SHOWVIEW™ Timer
	not timer-record properly.	set incorrectly.	Programming” ( pg. 32) and re-perform
			the procedure.
7.	“” and “$” on the front display	● The end of the tape was reached during	The programme may not have been
	panel won’t stop blinking.	Instant Timer Recording.	recorded in its entirety. Next time make
			sure you have enough time on the tape to
			record the entire programme.
8.	“N”, “” and “$” on the front display	● The loaded cassette has had its record	Remove the cassette and cover the hole
	panel won’t stop blinking.	safety tab removed.	with adhesive tape, or insert a cassette
			with the record safety tab intact.
		● The end of the tape was reached during	The programme may not have been
		Automatic Satellite Programme	recorded in its entirety. Next time make
		Recording.	sure you have enough time on the tape to
			record the entire programme.