JVC LPT0762-001B, HR-XVS20AA manual 78 EN, Ntscpal To playback a Ntsc tape on PAL TV, For Example

78 EN			SUBSIDIARY SETTINGS (cont.)
			* The default setting is bold in the table below.
8 NTSC	To record NTSC signals or playback a NTSC tape, it will be necessary to select
NTSC 3.58	the appropriate mode.
NTSC 4.43	NTSC 3.58: To record NTSC signals or playback a NTSC tape.
NTSC]PAL	NTSC 4.43: To record NTSC4.43 signals or playback a NTSC4.43 tape.
	NTSC]PAL: To playback a NTSC tape on PAL TV.
	NOTES:
	● The “NTSC]PAL” mode does not work during recording. In this mode, NTSC signals
	will be recorded as NTSC3.58.
	● The Menu screen is distorted during playing back a NTSC tape on PAL TV. Stop
	playback and access the Menu screen again.
	● In the “NTSC4.43” mode, with some TVs, on-screen displays (Program screen, etc.)
	may roll up or down and there may be a loss of colour. When this happens, select
	“NTSC3.58”.
8 O.S.D.	When this function is set to “ON”, various operational indicators appear on the
ON	TV screen.
OFF	NOTES:
	● When you use this unit as the source player for editing, be sure to set “O.S.D.” to “OFF”
	before starting.
	● During playback, the operation mode indicators may be disturbed depending on the
	type of tape being used.
8 AUTO SP]LP TIMER	When this function is set to “ON”, the unit automatically switches to LP mode
ON	to allow complete recording if there is not enough tape to record the entire
OFF	programme while timer-recording in SP mode.
	For Example:
	Recording a programme of 210 minutes in length onto a 180-minute tape
	Approximately 150 minutes		Approximately 60 minutes
	SP mode		LP mode
	Total 210	minutes
	Make sure you set this function to “ON”, before the timer-recording starts.
	NOTES:
	● If you have programmed the unit to timer-record 2 or more programmes, the second
	programme and those thereafter may not fit on the tape if you set “AUTO SP]LP
	TIMER” to “ON”. In this case, make sure the mode is not engaged, then set the tape
	speed manually during timer programming.
	● In order to ensure that the recording fits on the tape, this feature may leave a slight non-
	recorded section at the end of the tape.
	● There may be some noise and sound disturbance at the point on the tape where the unit
	switches from SP to LP mode.
	● The Auto SP]LP Timer feature is not available during ITR (Instant Timer Recording),
	and the feature will not work properly with any tapes longer than E-180, or with some
	tapes of shorter lengths.