Kathrein UFD 545 manual Analogue Settings, Video menu

Analogue Settings

As a rule, you will not need to change the analogue channels. With the advent of TV digitisation scarcely any new analogue channels will come on air. The relevant channel data are already set at the factory or are stored during the search scan.

Two menus displayed in white are available for tuning purposes.

Video menu

Press the M button to open the video menu. Use the oubuttons to

select the subpoints. Press the Obutton to save your settings.

Name

The name of the set-up channel is entered here. You can also change this name yourself. See section "Notes on operation/alphanumeric entry" for instructions on how to do this.

Frequency

The 5-digit frequency is entered in the range from 10700 to 12747 MHz with the number buttons 0…9. You can set the optimum reception frequency in steps

of 1 MHz by pressing the -+buttons (recommended when the picture experiences interference due to weak signals).

Polarity

Under this menu point, the vertical or horizontal polarization is set by means of a switching voltage (14 or 18 V) by pressing -or +.

Band

Here you can select the transmission band, i.e. the C-band 3.6…4.2 GHz or the KU-band 10.7…12.75 GHz. Your receiving system must, of course, be equipped for receiving these bands.

Low threshold

It may be necessary to change the low threshold setting only if reception conditions are poor. The standard setting is "1".

Observe the picture while changing the setting with the -or +buttons and set it to the least possible interference.

Contrast

Use the -or +buttons to set the contrast to a high level of picture brightness.

44