Timer Settings | Kathrein UFD 545 instruction

Timer Settings

You can use the timer for recording a programme with a video recorder on time. Seven timers are available which you can set to different channels as well as start and end times.

To access the timer setting, press Mto enter the main channel menu, uo

to go to system parameters, followed by Oand uoto local time / timer

and O. You now see the display shown below.

Press the oubuttons to move the cursor to the timer you require and confirm

it by pressing O. Press Lto exit the timer again.

Incorrect time settings will be rejected.

You can select and set

∙the channel type, TV or radio,

∙the channel location number with channel name,

∙the start time (date, month, year, hour, minute)

∙the stop time and

∙the timer status (inactive/once/daily/weekly)

for seven timers. You must enter leading zeros for the time settings.

Use the -+and the number buttons to make the required setting.

The current time that you must re-enter appears under the start time. If no other setting is entered, the end time will be set automatically to the same date and one hour after the start time.

Finally confirm the settings by pressing Mor Lthree times.

21

Image 21

Kathrein UFD 545 manual Timer Settings

Contents

DVB Satellite Receiver Page Important information Foreword Contents Timer Settings Sound Settings Glossary, Abbreviations Glossary of Technical Terms Safety Information Ventilation Setting-up locationMoisture, sunlight, heat Mains voltage Controls, Indicators, Displays and Connections Front viewRear view Channel Remote control function buttons Receiver on the command set Switching over between Remote Control Command Sets Menu concept Button functionsAlphanumeric entries Language selection OSD Connection and Startup Presetting of the receiving systemTo connect the receiver Sat-IF connection LNB supply voltage Inserting batteries in the remote controlModulator connection TV and video recorder connection Switching on for the First Time Factory setting of the receiverFirst steps Important on-screen displays OSD On-Screen Displays Channel selection Selecting a TV channelReception status digital Reception status analogue Switching over to radio channel Selecting a radio channel by number entry Timer Settings Setting the volume Sound SettingsStereo and two-channel sound reproduction Mute Channel Lists TV/radio Selecting TV and radio channels last receivedFavourite channels To delete a channel To sort the channels To add a channel Analogue channel lists To add an analogue channel Adding/Removing Satellites To set up satellites To remove satellites To enter a satellite name Current Channel Overview This function cannot be selected in analogue mode Password Factory settingEntering a password Parental control Operation in exceptional cases Operation from the Front Panel Local time/timer Setting System ParametersSystem parameters Parental control Summer time Timer menuTV type Picture format Mod.Ch Mod.typOSD colour OSD-Trans LNB configuration Installation Menu Changing the oscillator frequency Satellite scan Antenna settings Scan completed Press OK button TP setup/scan Analogue transponder KHz signal DiSEqC UFO setup Tone burst Preprogramming is not deleted under Reset Video menu Analogue Settings Audio mode HDP modeAudio menu Decoder Frequency left/right BandwidthDe-emphasis Video Recorder Connection RecordingPlayback Modulator reception Analogue Decoder Connection Preparation Data Transfer from Receiver to ReceiverTransferring channel list Transferring operating software Technical Reference Technical features HF features Technical data Scart socket assignments Accessories Connection arrangement Connection examples Analog DVB Glossary, Abbreviations DiSEqC Glossary of Technical Terms Symbol rate Service SatelliteDiSEqC menu DNR Index Index Page Page Page Page 998.6252/0800/ZWT/PF Subject to technical modifications