Switching on for the First Time
The first steps
Connect the receiver to the mains power supply or vehicle electrical system. Use the supplied connection cable for this purpose. Never connect both cables at the same time!
Switch on the receiver by pressing the power button at the front of the unit.
You will see "- - -
The operation indicator LED lights red, the receiver is now in standby mode.
Switch on your TV set.
Select an AV channel number on the TV set or select channel 38 if the modulator output is connected.
Switch on the receiver by pressing the ebutton on the remote control.
The orange LED at the front end of the receiver flashes every time a button on the remote control is pressed.
You will see the first factory preset channel on your TV screen. An information bar indicating the channel provider, the time, the timer settings, the channel status and the channel title will be displayed in the bottom section of the screen provided the corresponding data are transmitted. The number of the channel memory appears in the LED display.
The red standby indicator goes out.
You can now receive the TV and radio channels preset at the factory and select them by pressing the oubuttons. Press the Rand oubuttons to
select radio channels. Press the Ror T button to return to TV channels.
Refer to the section "Channel lists – TV/radio" for information on how to set up and save other TV and radio channels.
The reception status last set always reappears when the receiver is switched on.
If the message "bad or no signal" appears on the screen in addition to an on- screen display indicating the channel last received, you will need to check the system installation and/or the receiver settings. If this problem only applies to individual channel slots, the problem may be due to an interruption in the transmission signal or a fault in the receiving system (cable or satellite system).
In this case, first check the connection configuration and then check whether the basic settings of your receiver are correct for your system. In the case of doubt, have a specialist do this for you.
Factory setting of the receiver
Your receiver is preprogrammed to receive the ASTRA and HotBird satellites. You will normally need to make no further settings. To receive both satellite systems or other satellites you will require a multifeed arrangement with at least two LNBs in front of the satellite dish if you are not connected to a communal or party system. Please ask your dealer.
Before you change the basic settings of your receiver, note down the settings in the form provided at the end of this User's Guide. In this way, you will be able to restore the original settings at any time.
16
