
Installation Menu
Tone burst
Under this menu point, the 22 kHz signal can be set as follows:
Switching statuses of setting:
Switching statuses of setting:
Switching statuses of setting:
22 kHz Signal |
|
| 22 kHz Signal |
| 22 kHz Signal | |||||||||||
|
| and |
|
|
|
|
|
| and |
|
|
|
|
| and |
|
Tone Burst |
|
| Tone Burst |
|
| Tone Burst |
| |||||||||
Low |
| 22 kHz |
| OFF |
| Pos |
| Tone Burst | 22 kHz |
| Low |
| Tone Burst | 0 | ||
High |
| 22 kHz |
| ON |
|
|
|
|
|
|
| High |
| Tone Burst | 1 |
Pos. 1 | Tone Burst |
Pos. 2 | Tone Burst |
|
|
0
1
1
2
3
4
0OFF
0ON
1OFF
1ON
Pos. 1 Pos. 2
22kHz
22kHz
OFF
ON
DiSEqC
If the receiver is connected to a DiSEqC switchover matrix, you will need to set this menu point to ON.
The switching criteria and the input assignments of the DiSEqC switching matrix must be maintained. Therefore, refer to the description of the switching matrices or contact the installer of the receiving system.
DiSEqC repeat
The DiSEqC command must be repeated if the receiver is operated (cascaded) together with a receiving system with two or more series connected DiSEqC switching matrices.
In this case, switch the menu point "DiSEqC repeat" to 1 or 2.
Factory presetting: OFF
UFO mini
The input frequency of the receiver is fixed in a
The relevant setting that needs to be selected depends on the type of "user- controlled processing system".
The setting should be made according to the data provided in the installation instructions for the
Remote frequency
If you have set the UFO mini menu point to "ON" or "OFF", you will need to set the transmission frequency under this menu point.
Refer to the installation instructions of the
It is therefore important that you refer to the information provided in the installation instructions of the
UFO micro
The setting under this menu point is also designed for operation of the receiver together with a processing system.
Control and communication between the receiver and the Kathrein UFO micro system takes place on the return of the coaxial cable.
ON must be set under the UFO micro menu point if the receiver is operated together with a UFO micro receiving system.
During installation, the receiving system then assigns a special address to the receiver so that the control instructions that are sent from the receiver to the receiving system for signal selection are also recognized by this system.
A remote frequency need not be set in this operating mode as it is defined by the
42