Sound Settings, Setting the volume, Mute | Kathrein UFD 545 specification

Sound Settings

All setting options apply to analogue and digital TV modes as well as radio mode.

Setting the volume

Make sure that the volume of the TV set is set to the room volume.

Set the required volume level by pressing

the -+buttons on the remote control of the receiver. A bar indicator with 31 segments is displayed on the screen to show the set volume. The same procedure also applies to analogue reception.

Stereo and two-channel sound reproduction

(for radio and digital TV reception only)

Modulator connection

Stereo sound is not possible if the receiver signal is reproduced via the modulator.

The channel identifier that you can display by pressing the Obutton shows the set sound reproduction. (Depending on the direction of the symbolized sound waves – under the displayed time – mono left, mono right or stereo can be set. The digit indicates the number of transmitted sound channels). The channel title is shown in the box on the right.

Press the s button to call up the menu for sound and language selection. You can now make the required settings, e.g. language selection, provided the corresponding data are contained in the

reception signal. Press the button once again to exit the menu.

Mute

Press the lbutton on the remote control to mute the sound. This symbol l appears on the screen.

Press the l button again to restore the sound. The standard volume display bar is then shown for several seconds.

Although you can change the channel while in mute mode, it will remain muted until this mode is cancelled or you correct the volume.

22

Image 22

Kathrein UFD 545 manual Sound Settings, Setting the volume, Stereo and two-channel sound reproduction, Mute

Contents

DVB Satellite Receiver Page Foreword Important information Contents Timer Settings Sound Settings Glossary, Abbreviations Glossary of Technical Terms Safety Information Moisture, sunlight, heat Setting-up locationVentilation Mains voltage Front view Controls, Indicators, Displays and ConnectionsRear view Remote control function buttons Channel Switching over between Remote Control Command Sets Receiver on the command set Button functions Menu conceptAlphanumeric entries Language selection OSD To connect the receiver Presetting of the receiving systemConnection and Startup Sat-IF connection Modulator connection Inserting batteries in the remote controlLNB supply voltage TV and video recorder connection Factory setting of the receiver Switching on for the First TimeFirst steps OSD On-Screen Displays Important on-screen displays Selecting a TV channel Channel selectionReception status digital Switching over to radio channel Reception status analogue Selecting a radio channel by number entry Timer Settings Stereo and two-channel sound reproduction Sound SettingsSetting the volume Mute Selecting TV and radio channels last received Channel Lists TV/radioFavourite channels To sort the channels To delete a channel To add a channel To add an analogue channel Analogue channel lists To set up satellites Adding/Removing Satellites To enter a satellite name To remove satellites This function cannot be selected in analogue mode Current Channel Overview Factory setting PasswordEntering a password Parental control Operation from the Front Panel Operation in exceptional cases System parameters Setting System ParametersLocal time/timer Parental control TV type Timer menuSummer time Picture format OSD colour Mod.typMod.Ch OSD-Trans Installation Menu LNB configuration Changing the oscillator frequency Antenna settings Satellite scan TP setup/scan Scan completed Press OK button Analogue transponder DiSEqC UFO setup KHz signal Tone burst Preprogramming is not deleted under Reset Analogue Settings Video menu Audio menu HDP modeAudio mode Decoder Bandwidth Frequency left/rightDe-emphasis Recording Video Recorder ConnectionPlayback Analogue Decoder Connection Modulator reception Transferring channel list Data Transfer from Receiver to ReceiverPreparation Transferring operating software Technical features Technical Reference Technical data HF features Accessories Scart socket assignments Connection examples Connection arrangement Analog Glossary, Abbreviations DVB Glossary of Technical Terms DiSEqC Symbol rate Satellite ServiceDiSEqC menu Index DNR Index Page Page Page Page 998.6252/0800/ZWT/PF Subject to technical modifications