W'mding the Bobbin
[] Lift up the spool pin (_). Place the spool of
thread (_D on the spool pin with the thread
coming off the spool asshown.
Attach the large spool holder (_), and press it
firmly against the spool of thread.
[] Guide the thread around the thread guide.
[] Thread through the hole in the bobbin from the
inside to the outside. Put the bobbin on the
bobbin winder spindle.
(D Spool pin
(_) Spool
(_) Spool holder
(_) Additional spool pin
(_) Felt
(_) Additional spool pin hole
(_ Bobbin winder spindle
• Setting the spool
The small spool holder (_) isused with narrow or
small spools of thread.
To use the additional spool pin (_, guide the needle
thread as shown in [] and then [].
[] When using a regular spool
[] When using a small spool
[] When the thread jams around the spool pin C),
use the spool stand _).
(_ Spool holder (small) (_) Spool stand
• W'mding the Bobbin
• Push the bobbin to the right.
With the free end of the thread held in your
hand, depress the foot control. Stop the
machine when it hasmade a few turns, and cut
the thread dose to the hole in the bobbin.
Depress the foot control again. When the
bobbin isfirUy wound, it will stop automatically.
Return the bobbin winder to its ori_lal position
by moving the spindle to the left, and cut the
thread as shown.
* The machine will notsew until the spindle is
in the left position.
[]/ /