* Ice Fan Scroll Assembly Replacement
1)Remove the plastic guide for the slides on left side by unscrewing the phillips head screws.
2)Pull the grille forward as shown in the second picture.
3)Disconnect the wire harness of the grille
4)Remove the scroll assembly by loosening 2 screws
(1) | (2) | |
|
|
|
|
|
|
(3) | (4) |
8-5 DEFROST CONTROL ASSEMBLY
The defrost Control assembly consists of the Defrost Sensor and the
The Defrost Sensor works to defrost automatically. It is attached to the metal side of the Evaporator and senses its temperature. At 72°C, it turns the Defrost Heater off.
1.Pull out the grille assembly. (Figure 12)
2.Separate the connector with the Defrost Control assembly and replace the Defrost Control assembly after cutting the Tie Wrap. (Figure 13)
|
Figure 14 |
|
1.Unplug the Refrigerator or disconnect power at the circuit breaker.
2.If necessary, remove the top shelf or shelves.
3.Using a flat instrument, gently pry the cover loose in the front as shown. Rotate downward to remove rear tabs.
4.Make sure the bulbs are cool to the touch. Turn bulbs counterclockwise to remove.
5.Assemble in reverse order by snapping the Lamp Cover in, engaging the rear tabs followed by the front tabs. (Max. 60
Figure 15 |
|
1. | Unplug refrigerator power cord form outlet. |
2. | Using a flat instrument, gently pry the lamp cover |
| loose in the front as shown. Rotate downward to |
| remove the rear tabs. |
3. | Make sure the bulb is cool to the touch. Turn the |
| bulb counterclockwise to remove. |
4. | Replace with a new |
5. | Insert tabs on back of cover into slots in freezer |
GRILLE ASSEMBLY |
Figure 12 |
ASSEMBLY |
Figure 13 |
ceiling. Push cover up to snap front into place. |
8-7 CONTROL BOX-REFRIGERATOR
1.First, remove all shelves in the refrigerator, than remove the Refrigerator control Box by loosening 2 screws.
CONTROL BOX
COVER LAMP
Figure 16
2.Remove the Refrigerator Control Box by pulling it downward.
3.Disconnect the lead wire on the right position and separate the lamp sockets.
- 56 -
