8-8 MULTI DUCT
1.Remove the upper and lower 
aps by using a flat screwdriver, and remove 2 screws. (Figure 17)
2.Disconnect the lead wire on the bottom position.
8-9 MAIN PWB
1) Loosen the 3 screws on the PCB cover.
2) Remove the PCB cover
3)Disconnect wire harness and replace the main PCB in the reverse order of removal.
8-10 DISPENSER
1)Disconnect the funnel and button assembly by pulling down and forward.
Figure 17
2)Remove display frame assembly by making a gap between the display frame assembly and door
with a flat blade screwdriver and pulling it forward. The cover dispenser is attached with a hook.
wCAUTION: When replacing
the dispenser cover in the reverse order of removal, be careful that the lead wire does not come out and the water tube is not pinched by the dispenser cover, as shown in the picture below.
8-11 DISPLAY PCB REPLACEMENT
1)Pull up and out on the dispenser cover to remove.
2) Follow the steps in the pictures
8-12 FUNNEL REPLACEMENT
1)Pull up and out on the dispenser cover to remove.
2)Disconnect the wire harness.
3)Replace in reverse order.
- 57 -
