Kenmore 795.775646, 795.775796, 795.775636, 795.775736, 795.775726 Component Testing Information

7. COMPONENT TESTING INFORMATION

7-1. Defrost Controller Assembly

Function	- Controller assembly is consist of 2 kinds of part those are fuse-m
	and sensor. we can decide part is defect or not when we
	check the resistance.
	- Fuse-m can cut off the source when defrost heater operate the
	unusual high temperature.
	- Sensor give temperature information to Micom
How to		Set a ohmmeter to the 2 housing pin.
Measure		Measure the 2 pin connected to
(Fuse-M)	(1) to (2)	Fuse-M. If the ohmmeter indicate
		below 0.1ohm fuse-m is a good
		condition, But infinitely great ohm
		Fuse-M is disconnection

How to		Set a ohmmeter to The
Measure		2housing pin.
(Sensor)		Measure the 2 pin
		connected to Sensor.
	(1) to (2)	If the ohmmeter indicate 11kΩ
		(at room temperature)
		Sensor is not a defect.
		When check the ohm at other
		temperature Check
		the sensor manual.

Standard	Fuse-M (at all temperature)		Sensor (at room temperature)
	Test Point	Ressult	Test Point	Ressult
	(1) to (2)	0 ~0.1 Ω	(1) to (2)	11 Ω

- 44 -