ARemoval of Mtddle Spray Arm
1Remove stainless steeI cotter pin in lower end of plastic spray arm spindle underneath the black plastic supply arm
2 The spray arm and spindle can now be lifted off the supply arm
Removal of Upper Spray Arm Only
1 From below, in tub, remove two screws which hold spray arm and bearing assembly to plastic distributor (See Figure 18 )
2 The assembly will then drop loose If il is desired to remove the arm from the bearing assembly, the 1we screws the1 hold them together are nowraccessibte
NOTE
In Mid- 1980 [he design of the third ,spray arm was changed The spray arm is removed by removing the center moun_ing screw [See Figure 79]
BEARING
ASSEMBLY
&$
FIGURE18
ARM
;HER
(_SCREW
FIGURE19
Two Level - Compact Models
The top spray arm water supply system on all 18" (compact) dishwashers is completely external of the wash chamber, A hose from the back side of the pump housing runs behind the back center of the wash chamber (tub) up to the delivery tube
To remove: (See Figure 20)
1, Disconnect power supply to dishwasher,
2Loosenand removeclamp attaching delivery hoseto pump housing /VOTE: Water remaining in hose and pump should be caught in a bowl
3Remove four (4) screws that attach the delivery tube to the tub assembly,
4Remove hose by pulling slowly through the opening in rear of tub., Reverse procedure to reinstalf and check for leaks and kinks,
20
