;KET 807709

.GASKET 807710

LOCATING

CLAMPING RING 807T12

PUMP HOU 807711

FIGURE40

L_ Replacing Pump and Motor Assembly (Manufaclured in ]g78 or Later)

1,, Replace 8077:t0 gasket, DO NOT try to re-use original gasket, Be sure ridges on gasket face downward

2, Place pump and motor assembly in mounting hole in tub bottom. Be sure ports on pump housing are adjacent to connecting ends of drain and recircuiating hoses

3, Join together the two halves of the clamping ring on the pump housing Make sure the locating pins in the clamping ring halves are inserted in the holes in the pump housing° The joined ring will stay in position on the pump housing when it is properly assembled,

4, Install the pump mounting screws/MPORTANT,"/nstall one screw on each side of the ring F]RSS_ See Figure 4'1

5, Attach hoses to pump housing ports., Secure clamps with clamp screw on underside of hose

6, Connect motor leads disconnected in Step _4 in "Removing Pump and Motor Assembly,"

7., Replace lower spray arm, lower rack, toe plate, and access panel

INSTALL IHESE SCREWS FIRST

,)

TUB

FIGURE41

41

Page 44
Image 44
Kenmore 808353 manual Install Ihese Screws First TUB