Kenmore 808353 manual Center Motor Shaft with Pump Housing With Service Tool

CENTER MOTOR SHAFT WITH PUMP HOUSING

WITH SERVICE TOOL 803923--7

/

M

f

,!'...... ] ......

3____/

FIGURE37

SHIM GAUGE 807077_	_	.,p'--_	RAISE	EDGES	OF
		/	GASKET	TO	ALLOW

PUMPGAUGE HOUSINGTO SEAT ON

SURFACE

FIGURE38

10 Before repiacqng the required shims and lower impeller on the motor shaft, carefully examine the mating sur- faces of the lower impeller shaft seal (white ceramic) and the pump housing seal (black carbon) These surfaces

should be perfectly smooth and polished in appearance If either appears scratched, pitted or damaged in any fashion, the seal must be replaced otherwise a leak may occur

Clean seal cavity thoroughly Install the lower seal. Use service tool 803923.

11 Fasten motor pump housing assembly to tub Be sure casting is clean and a new gasket is used

12. Re-assemble remaining pump components in reverse order of removal

IMPORTANT:

Be sure the relay furnished in the kit is used with the replacement motor, otherwise, serious

damage to the motor can result! Carefully review the instructions packed with the motor

39