If the second wash or 'final rinse phase is prolonged for an excessive amount of time, causing the water to become hotter than necessary:

1.Check for too high calibration,, (Follow same procedure as outlined on the previous page )

2, Check the thermostat circuit for correct wiring

3Check to see that power is applied to one terminal of thermostat by the timer at the proper time.,

4.Check the heating etemenL

If 1 and 2 are satisfactory, a faulty thermostat is indicated and should be repiacedo

CA U TION:

Care should be taken when installing a replacement thermostat so as not to place any

strain or pressure on the body of the thermostat, Note that the thermostat is held in

position by a clamp on the wire leads,

Some Kenmore Dishwashers, both portable and built-in, are equipped with sensing devices to indicate to the user the temperature of the water within the machine. The water temperature will fall within the ranges of "Cool," "Normal," or "SanY' and wilt be indicated by lights on the console as shown in Figure 59.

TEMPERATURE INDICATOR LIGHT

DRY TIME SELECTOR TEMPERATURE DELAY

FIGURE59

The "coot" thermostat (Figure 60 )is a single pole single throw temperature controlled switch The "sani" thermostat (Figure 61) is a single pole double throw switch

C©OL THERMOS'fAT

'SANI'

THER MOSTAT

'@)I

FIGUREGO

52

Page 55
Image 55
Kenmore 808353 manual Figurego