Installation
Installation for Receiver unit
■Securing to audio board
1Attach the installation brackets to the sides of the hideaway unit using the sems bolts (M4 × 8 mm).
2Use the tapping screw (ø4 × 16 mm) to secure the hideaway unit to the audio board.
Installation brackets (Accessory K)
(ø4 × 16 mm) (Accessory N)
Sems bolts (M4 × 8 mm) (Accessory M)
■Securing to pile carpet
Peel the protective strips off of the velcro strips, attach them to the bottom of the hideaway unit, and secure to the pile carpet.
2CAUTION |
|
Please do not install the unit near the dashboard, the rear tray, or other |
|
important components. Doing so could lead to injury or accident should |
|
the unit come off due to a shock and strike a person or an important |
|
component. |
|
Tapping screws should be used for mounting. (Attachment with velcro |
|
strips, although easy, can come off with a shock.) | Velcro strips (Accessory L) |
|
Removing Monitor Unit
■Removing the Hard Rubber Frame
1Engage the catch pins on the removal tool and remove the two locks on the lower level.
Lower the frame and pull it forward as shown in the figure.
Lock Catch
Accessory J
2When the lower level is removed, remove the upper two locations.
NOTE
The frame can be removed from the top side in the same manner.
■ Removing the Unit
1 Refer to the section “Removing the Hard Rubber Frame” and then remove the hard rubber frame.
Catch facing up
2 Remove the
4Lower the removal tool toward the bottom, and pull out the unit halfway
while pressing towards the inside.
2 CAUTION
Be careful to avoid injury from the catch pins on the removal tool.
5Pull the unit all the way out with your hands, being careful not to drop it.
58
