External disc control mode
PROBLEM | POSSIBLE CAUSE | SOLUTION | ||
The disc control mode cannot | No cable has been connected to the disc | Connect the cable to the disc changer | ||
be selected. | changer input terminal on the unit. | input terminal on the unit. | ||
|
|
|
| |
The specified disc does not | The specified CD is very dirty. | Clean the CD. | ||
play, but another one plays |
|
|
| |
The CD is | Load the CD with the labelled side up. | |||
instead. | ||||
|
|
|
| |
| The disc is loaded in a different slot from that | Eject the disc magazine and check the | ||
| specified. | number for the specified disc. | ||
|
|
|
| |
| The disc is severely scratched. | Try another disc instead. | ||
|
|
| ||
The sound skips. | Something is touching the disc changer. | Remove whatever is touching it. | ||
|
|
|
| |
| The CD is scratched or dirty. | If skipping happens at the same place | ||
|
| when the car is stopped, something is | ||
|
| wrong with the CD. Clean the CD. | ||
|
|
|
| |
The display shows that the changer is being played, but no sound can be heard.
The computer chip in the unit is not functioning normally.
Press the reset button on the unit (see page 4).
The specified track does not | Random play or magazine random play has been | Turn off the random play or magazine | |
play. | selected. | random play function. | |
|
|
|
|
Track repeat, disc repeat, track | The setting is not cancelled. | The settings for these functions remain | |
scan, random play, and |
| on until the setting to off or the disc | |
magazine random play start by |
| ejected, even if the power is turned off | |
themselves. |
| or the source changed. | |
|
|
|
|
Cannot play | Finalization processing is not being conducted | Conduct finalization processing with CD | |
| for | recorder. | |
|
|
| |
| A | Use a CD changer compatible with CD- | |
| play the | ||
|
|
|
|
The following messages are displayed when certain problems are occurring in your system. Take the recommended actions.
BUS-E50
BUS-E11
Hot Error
More than two center units are connected.
More than two DSP/EQUALIZER units are connected.
The protective circuit in the unit activates when the temperature inside the unit exceeds 60°C (140°F), stopping all operation.
]Cool down the unit by opening the windows or turning on the air conditioner. As the temperature falls below 60°C (140°F), the disc will start playing again.
Mecha Error The disc player is malfunctioning.
]Eject the disc and try inserting it again. Contact the Kenwood dealer if this indicator continues blinking or the disc cannot be ejected.
Disc Error
Read Error
The unplayable discs is inserted
The disc is
]Load the disc with the labeled side up. The disc is quite dirty.
]Clean the disc, referring to the section on "Cleaning discs" (see p. 5).
Region code Error
Parental level Error
Error 07
Error 17
Error 27
Error 37
Error 47
Error 57
Error 67
The DVD software encoded for other region code.
The parental level is set to high levels.
The unit is malfunctioning for some reason.
]Press the reset button on the unit. If the "E- ##" code does not disappear, consult your nearest service center.
67
