Kenwood KVT-920DVD Setting the Screen Mode, Setting the Priority Language for Menu

DVD/VCD Setup Function

	DVD Setup Screen-1			DVD Setup Screen-2
A	B	C	E	G	H

D F I

ASetting the Screen Mode

Use the procedure described below to set the output screen.

Each time you touch [ Screen ], the mode switches as follows:

" 4:3 LB "

Wide-screen software with pan & scan specification is played in a letter box screen (with black stripes on the top and bottom).

" 4:3 PS "

Wide-screen software with pan & scan specification is played in a panned & scanned screen (with the left and right sides cut off).

" 16:9 "

Set the picture mode of the wide-screen monitor to “FULL”

BSetting the Priority Language for Menu

Set the language used for the menus (title menu, etc.).

Touch [ Menu Lang ] to switch the language select screen. <see p.18>

CSetting the Priority Language for Subtitle

Set the language of the subtitles displayed on the screen.

Touch [ Subtitle ] to switch the language select screen. <see p.18>

disc. If the initially set language does not exist in the disc, the priority language defined for each disc is used.

ESetting the Angle Mark Display

With DVDs on which images photographed from multiple angles are recorded, the angle can be switched during playback.

Each time you touch [ Angle Mark ], the mode switches as follows:

" ON "

Angle mark is displayed.

" OFF "

Angle mark is not displayed.

FSelecting the Dynamic Range

Each time you touch [ DRC ], the mode switches as follows:

" Standard "

For more powerful sound at regular volumes

" Midnight"

For powerful sound at low volumes

" OFF "

For the regular sound

NOTE

This select can be made when the Dolby Digital signal is inputed.

NOTE

The language selected in the initial setup is used immediately after turning power on or replacing disc. If the initially set language does not exist in the disc, the priority language defined for each disc is used.

DSetting the Priority Language for Voice

Set the audio language produced from the speakers.

Touch [ Audio ] to switch the language select screen. <see p.18>

NOTE

The language selected in the initial setup is used immediately after turning power on or replacing

16