184 Effects
Filter/Dynamic
If Sweep Mode is set to LFO, the sound will change cycli-
cally from “a” to “i,” “u,” “i,” then “a.”
h: Formant Shift
This parameter adjusts the frequency level to which the
effect is applied. If you wish to apply the effect to a
higher-range sound, set this parameter to a higher value;
to apply the effect to a lower-range sound, set this to a
lower value.
h: Resonance
This parameter sets the intensity of resonance for the
voice pattern. A larger value will add more character to
the sound.

014: Decimator

(Stereo Decimator)

This effect creates a rough sound like a cheap sampler by low-

ering the sampling frequency and data bit length. You can

also simulate noise unique to a sampler (aliasing).

a: Pre LPF
If a sampler with a very low sampling frequency receives
very high-pitched sound that could not be heard during
playback, it could generate pitch noise that is unrelated to
the original sound. Set “Pre LPF” to ON to prevent this
noise from being generated.
If you set the “Sampling Freq” to about 3kHz and set “Pre
LPF” to OFF, you can create a sound like a ring modulator.
e: Resolution, f: Output Level
If you set a smaller value for the “Resolution” parameter,
the sound may be distorted. The volume level may also be
changed. Use “Output Level” to adjust the level.
+ Max
Zero
D-mod
– Max
Voice Bottom Voice Center Voice Top
U
I
A
A
O
E
JS
X
Ribbon
JS +Y
JS –Y
etc… Zero + Max
Talking Modulator Control
a
Pre LPF Off, On
Selects whether the harmonic noise caused by a decrease in sampling fre-
quency is generated or not ☞
High Damp [%]
Sets the ratio of cut of the high range
0...100%
b
Sampling Freq (Sampling Frequency) [Hz]
Sets the sampling frequency
1.00k...48.00kHz
Src Off...Tempo
Selects the modulation source of the sampling frequency
Amt –48.00k...+48.00kHz
Sets the modulation amount of the sampling frequency
c
LFO Frequency [Hz]
Sets the LFO speed
0.02...20.00Hz
Src
Selects the modulation source of LFO speed
Off...Tempo
Amt –20.00...+20.00Hz
Sets the modulation amount of LFO speed
d
Depth 0...100
Sets the depth of the sampling frequency LFO modulation
Src Off...Tempo
Selects the LFO modulation source of the sampling frequency
Amt –100...+100
Sets the LFO modulation amount of the sampling frequency
eResolution
Sets the data bit length
4...24
☞
f
Output Level
Sets the output level
0...100
☞,
Src
Selects the modulation source for the output level
Off...Tempo
Amt
Sets the modulation amount of the output level
–100...+100
g
Wet/Dry Dr y, 1:99...99:1, Wet
Table , “Sets the balance between the effect and dry sounds,” on page 175
Src Off...Tempo
Table , “Selects the modulation source of the effect balance,” on page 175
Amt
Table , “Sets the modulation amount of the effect bal-
ance,” on page 175
–100...+100
Left
Right
Wet / Dry
Wet / Dry
Stereo In - Stereo Out
Pre LPF
Pre LPF
High Damp Output Level
High Damp Output Level
Sampling Frequency
Decimator
Decimator
D-mod
LFO
Resolution
Resolution