The computer responds with:

Write data into CMOS and exit (Y/N)?

Press Y. The computer will update the information in its configuration RAM, and will go through the start-up routine again. Make sure MS-DOS is installed on floppy disk or hard disk of your system, so the system will boot up in MS-DOS.

Note

Your system has an on board IDE type HDC and if you want to install the another type of HDD except IDE, you must disable the on board IDE HDC using the Extended Setup Program. See Chapter 2 for the detailed information of it.

Partitioning Your Hard Disk

After the DOS Shell screen appears, select the Command Prompt option. At this point your are ready to partition your hard disk drive.

To do this, enter the command:

A > FDISK

After loading the FDISK program, the computer will display information on the hard disk drive installed in the system, as follows:

6-6 Using Your Hard Disk