Note

If your system’s start-up message does not show any errors and proceeds to try to load software from the floppy disk drive, you see the following message:

Entering SETUP

To enter the setup program, hit < DEL > key at the time the following prompt is displayed on the screen immediately after the memory test.

Press <DEL> if you want to run SETUP/EXTD-SET

If you hit <DEL> key, you will see a menu like as following

EXIT FOR BOOT

RUN CMOS SETUP

RUN XCMOS SETUP

This means that the SETUP program options have been set at the factory. Since there were no errors detected, the computer tried to load MS-DOSfrom the floppy disk drive, before you have inserted the MS-DOSmain system diskette. For now ignore this message.

2-6 Running the Setup Program