Internal Hard Disk Drive

If you are to mount the internal hard disk drive inside the main system unit case, follow the steps below:

Remove the cover from the main system unit, as described above.

Remove mounting plate by unscrewing the hold down screws.

Attach the hard disk drive to the mounting plate by installing the four mounting screws through the bottom of the plate into the bottom of the drive frame.

Replace the mounting plate onto the mounting frame by sliding the plate into the two openings provided in the mounting frame.

Replace the hold down screws.

Connect the hard disk drive controller cables to the drive.

Replace the main system unit cover.

N o t e

Your system has an on board IDE type HDC and if you want to install the another type of HDD except IDE, you must disable the on board IDE HDC using the Extended

Setup Program. See Chapter 2 for the detailed information of it.

Expanding Your System

7-15