INCORRECT

ELECTRlCAL RESTRICTIONS

Figure 7-4. Installing the Option Card in an Expansion Slot

Check the board’s alignment to make sure it is straight and level. If necessary, move the board slightly to align the hole in the top of the mounting bracket over the screw hole in the main system unit’s rear panel flange. Install the holddown screw that you removed earlier.

Reconnect any internal cables that were disconnected earlier. If you have a problem making the cables reach their connectors, you may have to move the board you just installed to another slot. If any external equipment is used with the expansion board, connect it to the board’s rear panel connector(s), following the instructions given with the product.

When the installation of the board is completed, close the main system unit cabinet as described above.

Disk Drive Compartments

To install expansion devices such as additional floppy disk drives into the main system unit’s disk drive compartments, follow the procedure given below.

First, make yourself familiar with the specific installation procedure for the expansion device by reading all of the

Expanding Your System

7-13