documentation provided. Then, remove the main system unit cover as described above. Select the drive compartment where you will install the expansion device. Remove the blank front panel from the selected compartment by removing the mounting screws.
Slide the expansion device into the compartment along the side rails of the drive cage until it is all the way in. Replace the hold down clamps and their mounting screws.
Connect any internal power cables to the correct pins on the rear of the expansion unit. Connect any required control cables to the device. Close the main system unit cabinet as described above.
Note
Your main system unit is supplied with the cables necessary to connect two floppy disk drives to the system motherboard. Follow the instructions provided with the expansion floppy disk drive for proper installation.
Figure