Power Connector - J6, J15

The system board requires four DC voltage: + 12V, -12V, +5V, and -5V.

The power connector respectively supply power to the system board and to the six expansion slots.

Speaker - J25

Connector J25 provides a speaker connection for audible tone generation. The connector is a two pin header.

IDE Interface connector - J24

You use this 40 pin connector with IDE type Hard disk drive.

Note

Your system has an on board IDE type HDC and if you want to install the another type of HDD except IDE, you must disable the on board IDE HDC using the Extended Setup Program. See Chapter 2 for the detailed information of it.

If you want to know the detailed pin assignment of those I/O connectors, see Appendix D of this manual,

System MotherBoard B-7